Products made from additive manufacturing processes have attracted great attention in engineering, health care, and society at large. However, there is little knowledge about the failure of additively manufactured alloys, in particular, corrosion and wear seen in most engineering applications. The haphazard and inefficient usage of such alloys raised concerns about safety, compatibility, reliability, cost, and consumer satisfaction. To address those concerns, we studied the mechanisms of the most common failure modes, corrosion and wear, of alloys fabricated through additive manufacturing based on published literature. It was found that the processing conditions have profound influence on microstructure and thus corrosion and wear resistance of alloys. Because of the layered structure, the initiation and growth of both corrosion and wear exhibited anisotropic behavior. The insights from this review could be used as a reference of the state-of-the art and to help in the development of future additively manufactured alloys with improved corrosion and wear properties.
11 January 2020 in Journal of Materials Chemistry C
In order to meet our increasing energy demand, a flexible, lightweight, and highly organized energy management strategy is needed for flexible supercapacitors. With that perspective, an anode electrode has been designed by depositing NiWO4 nanoparticles on lignin (lig) on an aluminum substrate. A supercapacitor was assembled by using Al/lig–NiWO4 as the anode, Al/AC (activated carbon) as the cathode, and PVA/H3PO4 gel as the electrolyte. Superior electrochemical performance was achieved even after 2000 cycles of charge and discharge study. The maximum specific capacitance at 0.13 A g−1 is 17.01 mF cm−2, which is more than 42 times that reported. The capacitance retention is maintained at about 97% after 1000 cycles, and at 84% after 2000 cycles. The maximum energy and power densities are 2 W h cm−2 and 100 W cm−2, respectively. A series of the composition of lig : NiWO4 : PVDF was tested to optimize the electrochemical performance. It was found that the best performance was achieved for the ratio (10 : 80 : 10) that had predominantly NiWO4 nanoparticles. The remarkable electrochemical performance of this new class of capacitors makes them useful for a wide variety of electronics.