[1] Distributed temperature sensing (DTS) was used to map spatial and temporal changes in temperature on a 25 m by 6 m lakebed area in the winter (February), spring (May), and summer (August) of 2012. A constant and high discharge of groundwater with the average temperature of around 8°C to the lake will result in either lower (summer) or higher (winter) daily temperatures and reduce temperature variability at the sediment-water interface (SWI). DTS data were used as a proxy for groundwater discharge using three metrics; daily minimum temperature, diel amplitude, and daily standard deviation of temperature. During the seasons, the daily minimum temperatures at the SWI indicate a discharge zone 4–6 m offshore. From winter to summer, the extent of this zone changes and the SWI temperatures also show a shift of discharge locations toward the shore. Fluxes estimated on the basis of vertical temperature profiles from the top 50 cm of the lakebed and seepage meters in August compare well with the locations of the high-discharge zones detected by the DTS in the same period, giving confidence in the ability of the method to map both the areas and spatial variability of groundwater discharge to lakes. Compared to February, the DTS was able to detect new relatively cold temperature zones at the SWI in May and August indicating that groundwater discharge to the lake changes over time and that DTS can be used to monitor temporal variability in areas of discharge.

Observed 3-D temperature distributions within a streambed were used to analyze the effects on exchange fluxes between groundwater and the stream during rainfall-runoff events. By combining a dense vertical and lateral monitoring network of streambed temperatures with coupled surface/subsurface 3-D flow and heat transport modeling, we demonstrate how temperature can be used directly as a calibration target. Three model setups with different hydraulic conductivity distributions were evaluated in an optimization approach using temperature and hydraulic head data. The hydraulic conductivity distributions were based on slug test surveys within the streambed and aquifer. A detailed characterization of the hydraulic conductivity of the streambed and aquifer is needed to accurately simulate observed temperatures. Hence, the most sensitive parameters, the vertical hydraulic conductivity and the thermal conductivity, were calibrated within different conductivity zones of the heterogeneous model. Simulated exchange fluxes across the streambed showed variations up to a factor of four within just a meter. Such differences may not have been correctly predicted using 1-D heat transport models due to lateral conduction amongst the different flow paths. During the rainfall-runoff event, fluxes decreased substantially (−50%) due to a decrease in the hydraulic gradient with increased stream stage. Although no flow reversals were observed during the studied conditions, it is possible that these can occur during larger rainfall-runoff events. We show that with the current sampling and modeling techniques, 3-D temperature data can be used to estimate dynamic exchange in heterogeneous flow fields encountered in the field.