By posing the question of what will be the definition of sustainable development in the future, it can almost be seen that the principle of “no waste” and the production of new materials with less of a negative environmental impact will have a high priority. To further develop environmentally friendly materials, it is necessary to know about the environmental drivers of new materials as well as to evaluate the environmental effects of conventional materials in construction. According to the definitions of sustainable development and sustainable materials, materials with characteristics such as having low energy consumption, sufficient durability, good physical and chemical properties, while simultaneously reducing pollution should be used. Geopolymer materials may be a reasonable option. In this research, two production processes based on blast furnace slag and ordinary concrete (Portland cement) for one cubic meter of geopolymer concrete have been investigated. To investigate, inputs (materials and energy) and outputs (relevant environmental pollutants) of both systems were determined and a life cycle assessment (LCA) was measured using the Center of Environmental Science of Leiden University (CML) and cumulative exergy demand (CED) quantification methods of SimaPro V.9 software. The results showed that the production system of one cubic meter of conventional concrete has maximum environmental effects in all classes except in the destruction of the ozone layer, and the system of producing one cubic meter of geopolymer concrete based on slag has much less environmental effects than the normal concrete system. It also consumes 62% less directly during its lifetime. As a result, geopolymer concrete may be a suitable alternative to traditional concrete as a sustainable material.
4 March 2024 in International Journal of Environmental Science and Technology
Today, concrete is the most widely used building material. Cement production releases about 7% of carbon dioxide gas into the atmosphere and increases greenhouse gases, so it seems necessary to use an alternative to Portland cement. In recent years, geopolymers (mineral polymers) have been proposed as a new environmentally friendly cement. Metakaolin, bentonite, zeolite, iron blast furnace slag and fly ash can be mentioned as aluminosilicate sources. In the field of geopolymer concrete construction, few articles have been working on the composition and effect of replacing aluminosilicate sources. In this experimental study, the effect of replacing slag aluminosilicate sources, class F fly ash and bentonite with proportions of 5-45% with metakaolin on the mechanical properties and durability of geopolymer concrete based on metakaolin was investigated. After making the samples, compressive, bending, tensile and carbonation tests were performed on the geopolymer concrete samples to obtain the optimal strength and carbonation depth of the samples. Also, to determine the validity of the tests, machine learning estimation analysis was performed on the samples. The findings showed that bentonite leads to a decrease in strength, while fly ash and slag lead to an increase in strength. The predicted R2 values showed the highest matching of the correlation matrix (more than 93%) for the pressure samples. In addition, the results of the tests showed that the metakaolin-based geopolymer concrete sample replaced with fly ash (35%) had a lower penetration depth (carbonation) and higher mechanical properties than other samples.