Water droplets (0.55 or 1.3 mm diameter) were photographed as they impinged on a stainless steel surface. The droplet impact velocity (10–50 m s−1) and the average roughness (0.03 or 0.23 μm) of the test surfaces were varied. The stainless steel substrate was mounted on the end of a rotating arm, giving linear velocities of up to 50 m s−1. Different stages of droplet impact were photographed by synchronizing the ejection of a single droplet with the position of the rotating arm and triggering of a camera. Finger-shape perturbations were observed around the edges of spreading droplets. The maximum diameter to which a droplet spread and the number of fingers formed around it were measured. The size and number of fingers increased with impact velocity and droplet diameter. At sufficiently high velocities, the tips of these fingers detached, producing satellite droplets. By increasing surface roughness, both the number of fingers and the maximum extent of spreading were decreased. At high impact velocities the spreading liquid film became so thin that it ruptured in several places. A mathematical model, based on linear Rayleigh–Taylor instability theory, was used to predict the wavelength of the fastest growing perturbation around a spreading droplet. The corresponding wavenumber agreed reasonably well with the number of fingers around the droplet.
Thermal spray deposition techniques have been well-established, owing to their flexibility in addressing degradation due to wear and corrosion issues faced due to extreme environmental conditions. With the adoption of these techniques, a broad spectrum of industries is experiencing continuous improvement in resolving these issues. To increase industrial-level implementation, state-of-the-art advanced materials are required. High-entropy alloys (HEAs) have recently gained considerable attention within the scientific community as advanced materials, mainly due to their exceptional properties and desirable microstructural features. Unlike traditional material systems, high-entropy alloys are composed of multi-component elements (at least five elements) with equimolar or nearly equimolar concentrations. This allows for a stable microstructure that is associated with high configurational entropy. This review article provides a critical assessment of different strengthening mechanisms observed in various high-entropy alloys developed by means of deposition techniques. The wear, corrosion, and oxidation responses of these alloys are reviewed in detail and correlated to microstructural and mechanical properties and behavior. In addition, the review focused on material design principles for developing next-generation HEAs that can significantly benefit the aerospace, marine, oil and gas, nuclear sector, etc. Despite having shown exceptional mechanical properties, the article describes the need to further evaluate the tribological behavior of these HEAs in order to show proof-of-concept perspectives for several industrial applications in extreme environments.
This work presents a novel coating technique to manufacture ceramic superhydrophobic coatings rapidly and economically. A rare earth oxide (REO) was selected as the coating material due to its hydrophobic nature, chemical inertness, high temperature stability and good mechanical properties and deposited on stainless steel substrates by solution precursor plasma spray (SPPS). The effects of various spraying conditions including standoff distance, torch power, number of torch passes, types of solvent and plasma velocity were investigated. The as-sprayed coating demonstrated a hierarchically structured surface topography, which closely resembles superhydrophobic surfaces found in nature. The water contact angle on the SPPS superhydrophobic coating was up to 65% higher than on smooth REO surfaces.