View Video Presentation: https://doi.org/10.2514/6.2022-1545.vid Novel techniques to reduce the negative effects of modern aviation on the environment have been studied for several decades. Among these techniques, one can mention the morphing of the lifting surfaces of an aircraft (wing and flaps), which allows to reduce the weight by removing some mechanisms, while optimizing more finely and in a controlled way the shape of the wings and control surfaces during the different flight phases. On the other hand, there are flow control techniques that are developed and used, such as vortex generators and blowing-suction devices, in order to control the structure of the flow on the lifting surfaces, and thus reduce the drag. The present study proposes a coupling of these 2 types of devices, namely the camber of a flap allowing an increase in lift, coupled with Zero Net Mass Flux (ZNMF) devices that will permit a separated flow that might occur with important camber to reattach. The combination of these both devices is investigated using three-dimensional CFD simulations by means of hybrid RANS/LES turbulence modelling.
View Video Presentation: https://doi.org/10.2514/6.2021-2854.vid This study investigates the physical mechanisms of the use of Active Flow Control (AFC) associated with morphing through cambering approach in a high-lift wing-flap system. Results of high-fidelity numerical simulations are examined at high Reynolds number (Re/c) of 4.6 Million. Adapted turbulence models are used to capture the flow separation and the development of coherent structures. Different approaches of AFC are proposed to suppress the flow separation located approximately at 60% of the cambered flap's chord. The present study focuses on AFC using steady continuous jet, unsteady valves or oscillators (pulsed blowing) and more precisely the Zero Net Mass Flux (synthetic jet) with the blowing-suction approach. The AFC at an optimal velocity and frequency of actuation enabled an enforcement of the flow re-attachment and a delay of the flow separation. The minimum jet velocity and a feasible vibration frequency are discussed providing a practically complete control of the separation regarding the high deflection angle and cambering dimensions. As a main result of the study, the pressure distribution is enhanced over both wing-flap surfaces, adverse pressure gradients are suppressed and the re-attachment of the boundary layer is obtained. These results have the potential to increase significantly the aerodynamic efficiency of aircraft during the take-off and landing phases.
19 April 2026 in International Journal of Heat and Mass Transfer