A 10 kA high-temperature superconductor current lead (HTS-CL) using a double-tube stainless steel (SS) shunt has been designed, fabricated, and tested at Institute of plasma physics, Chinese Academy of Sciences (ASIPP). The current lead consists of 80 parallel the second generation HTS coated conductor with critical current of 220 A at 77 K in self-field, a double-tube SS shunt, and Cu connectors. The 80 YBCO tapes are divided into 20 so-called panels, which are soldered into the 20 grooves on the surface of the double-tube SS shunt and Cu connectors, each panel contains four parallel YBCO tapes. A double-tube shunt consisting of two coaxial tubes is designed. A series of tests were performed to verify the feasibility of the HTS-CL. The measured joint resistance is about 0.3–0.4 μ Ω/cm 2 . The transport current of 10.515 kA was carried between 5 and 65 K for 1010 s with no quenching. The LOFA time of 569 s and the burnout time over 15 s meeting the design requirements.
As a new zero-carbon fuel, ammonia co-firing in coal-fired boilers is one of the feasible technologies for reducing carbon emission. This study validated an ammonia-coal co-firing simulation model using experimental data from a 300 MW unit tangential firing boiler, and investigated the impacts of different ammonia injection methods (uniform injection, lower layer concentrated injection and upper layer concentrated injection) at 20% ammonia co-firing ratio on boiler performance. Key findings include flow fields characteristics: uniform injection enhanced the tangential flow pattern, while pure ammonia burners in concentrated injection modes exhibited weaker tangential momentum compared to coal burners; combustion and temperature fields: all the three injection methods reduced peak furnace temperatures but increased flue gas temperature at furnace outlet; coal burnout performance: uniform injection and lower layer concentrated injection inhibited coal burnout, whereas upper layer concentrated injection promoted it; NOx emissions: both uniform injection and lower layer injection reduced NOx emissions, while upper layer injection significantly increased them. These conclusions provide critical guidance for retrofitting power plant boilers for ammonia co-firing.
1 May 2019 in Journal of Physics: Conference Series
The China Fusion Engineering Test Reactor (CFETR), a superconducting magnetic confinement tokamak fusion reactor, will develop a high-performance torus cryopump to pump torus plasma exhaust gas. The inlet valve is one of the key components of the cryopump, and it is used to isolate the cryopump from the plasma for regeneration, to control the pumping speed of the cryopump, and to operate as a pressure relief valve in case of a failure, such as the cryopipe breaking inside the cryopump chamber. This paper presents a novel inlet valve. Ensuring that the design of the inlet valve meets the above requirements will be a challenge. In order to verify the reliability of the inlet valve, its critical components are analyzed and optimized by the Finite Element Method. The effect of the stroke of the inlet valve on pumping performance is then estimated by the Monte Carlo Method, and the pressure profile in the whole flow field is studied to predict the cryopump’s behavior. Finally, the seismic capacity of the optimized inlet valve is analyzed, and the mechanical performance of the inlet valve is shown to meet CFETR design criteria. These design and analysis results will provide technical support and references for the development of the CFETR torus cryopump.