Computational fluid dynamics (CFD) is an effective tool for ship resistance prediction and hull form optimization. A three-dimensional volume mesh is essential for CFD simulation, and mesh generation requires much time and effort. Mesh deformation can reduce the time for mesh generation and simulation. The radial basis function (RBF) and inverse distance weighted (IDW) methods are well-known mesh deformation methods. In this study, the two methods are compared and a novel mesh deformation method for hull form optimization is proposed. For the comparison, a circular cylinder polyhedral mesh was deformed to the National Advisory Committee for Aeronautics (NACA) 0012 mesh. The results showed that the RBF method is faster than the IDW method, but the deformed mesh quality using the IDW method is better than that using the RBF method. Thus, the RBF method was modified to improve the deformed mesh quality. The centroids of the boundary layer cells were added to the control points, and the displacements of the centroids were calculated using the IDW method. The cells far from the ship were aligned to the free surface to minimize the numerical diffusion of the volume of fluid function. Therefore, the deformable region was limited by the deformed boundary, which reduced the time required for mesh deformation. To validate its applicability, the proposed method was applied for varying the bow shape of Japan Bulk Carrier (JBC). The resistances were calculated with the deformed meshes. The calculation time was reduced to approximately one-third using the result of the initial hull form as the initial condition. Thus, the proposed mesh deformation method is efficient and effective enough for CFD-based hull form optimization.
Exhaust smoke discharged from marine vessels and offshore plants not only contaminates the hull and cargo but is also the main cause of deterioration in the crew’s health and working environment. Rules and regulations have been implemented and have become stricter in recent decades. In this study, the exhaust smoke flow around an anchor-handling tug supply vessel in a stationary state, which has been seldom studied, is analyzed using computational fluid dynamics. The study investigates the effect of changing the wind speed and direction, which primarily affects the flow and dispersion of the smoke, to verify the suitability of the environment for the crew. To assess the environment, the recommended and comfortable concentrations of NO2 are used. The results demonstrate that a higher wind speed worsens the effect of the exhaust flow on the environment, owing to lower-pressure values and regions behind the structures. The emission of exhaust smoke is unsatisfactory when the wind flows from the side or rear of the vessel, instead of from the bow. Differing from previous studies conducted on general merchant vessels in navigating conditions, it was found that side winds can also have detrimental environmental effects in the stationary state. Adopting the original design of exhaust pipes leads to the distribution of exhaust smoke over the deck, exceeding the recommended exposure limit. Increasing the height of the pipes is identified as a simple but effective method to facilitate the smooth discharge of exhaust smoke.
When performing simulations using computational fluid dynamics, the grid systems in the viscous boundary layer regions are important because the velocity and pressure change very rapidly in these regions. Especially for the turbulent flows, thin grids should be arranged densely in the direction perpendicular to the wall. In this study, the advancing layer method, which has been applied mostly to tetrahedral meshes, is applied to trimmed hexahedral meshes. To generate boundary layer meshes with non-intersecting grid lines near the wall boundaries having concave corners and narrow gaps, the directional vectors of grid lines and faces are smoothed, and the displacement vector fields calculated using the Laplace equation were utilized. Firstly, the details on the newly developed methods are introduced showing simple two-dimensional cases as examples. After applying the methods for a complex three-dimensional geometry to check its applicability and investigating the generated grid systems, the numerical simulations of propeller open water test for INSEAN E779A marine propeller were carried out by simpleFoam, one of the standard solvers of OpenFOAM. The computational results showed good agreement with the experimental results. Therefore, in conclusion, the developed advancing layer method is an appropriate method for generating boundary layer grids of a trimmed hexahedral mesh.