Regulating the surface properties of catalysts to control the selectivity of a reaction is a fascinating approach. Bulk polymeric carbon nitride exhibits a poor N-phenylhydroxylamine yield in nitrobenzene reduction reaction mainly due to the uncontrollable condensation side reactions. Thus, adjusting the structure of the catalyst was key to solving the above issue. Herein, –OH groups-modified polymeric carbon nitride was prepared via a simple hydrothermal treatment. With the introduced –OH groups replacing the terminal amino groups (–NH2) at the surface of the polymeric carbon nitride, a 3-fold increase in reaction rate was achieved, along with a high selectivity toward N-phenylhydroxylamine (ca. 80%). The introduced –OH group was found to be beneficial to the adsorption of the nitrobenzene, based on the density functional theory (DFT) calculation. It could also lower the recombination rate of photoinduced electron–hole pairs, which would accelerate the photocatalytic oxidation of isopropanol and supply more protons to participate in the hydrogen-transfer process. Moreover, the elevated conduction band position after –OH modification would provide high energetic photogenerated electrons to promote the reduction of nitrobenzene. These are all important to guarantee the highly selective production of N-phenylhydroxylamine. This paper not only provides a simple and green approach for the modification of polymeric carbon nitride toward an efficient photocatalyst, but also sheds light on the further study of the selective hydrogenation.
Polymeric carbon nitride is a promising candidate for metal-free photocatalysis, but it is hampered by low activity due to poor carrier separation efficiency and lack of active sites.
1 April 2021 in Applied Catalysis B: Environment and Energy
The selective hydrogenation of furfural (FAL) to furfuryl alcohol (FOL) under mild conditions using a non-noble metal catalyst is highly desirable in biomass conversion. Commercial FOL production over a Cu-based catalyst suffers from harsh reaction conditions and significant deactivation due to catalyst instability. Herein, we report stable Cu nanoparticles encapsulated in a few layers of carbon prepared by the pyrolysis of the metal–organic framework HKUST-1 in H2/Ar, which exhibited excellent catalytic performance and stability in FAL hydrogenation under visible light irradiation. The Cu nanoparticles could absorb visible light and generate photoexcited electrons due to the localized surface plasmon resonance (LSPR) effect, and these electrons transferred the energy to the molecules absorbed on the Cu NP surface, inducing effective dissociation of H2 and hydrogenation of FAL. This study provides guidance for designing stable Cu-based LSPR photocatalysts and a mild route for biomass conversion in compliance with green chemistry.
The controlled generation of reactive oxygen species (ROS) to selectively epoxidize styrene is a grand challenge. Herein, cyano-group-modified carbon nitrides (CNCYx and CN-Ty) are prepared, and the catalysts show better performance in regulating ROS and producing styrene oxide than the cyano-free sample. The in situ diffuse reflectance infrared and density functional theory calculation results reveal that the cyano group acts as the adsorption and activation site of oxygen. X-ray photoelectron spectroscopy and NMR spectrum results confirm that the cyano group bonds with the intact heptazine ring. This unique structure could inhibit H2O2 and ⋅OH formation, resulting in high selectivity of styrene oxide. Furthermore, high catalytic activity is still achieved when the system scales up to 2.7 L with 100 g styrene under solar light irradiation. The strategy of cyano group modification gives a new insight into regulating spatial configuration for tuning the utilization of oxygen-active species and shows potential applications in industry.