Development of the electric propulsion systems for future electric aircrafts is one of the most important challenges in aviation science. Moving away from fossil fuels and transition to clean hydrogen energy involves the use of electric machines to produce thrust in future aircraft. However, such a transition also requires new electrical equipment that can operate at cryogenic temperatures of liquid hydrogen, which will be used as fuel for future aircraft. The article describes an approach to the development of a Hydrogen Electric Propulsion System (HEPS) for future aircrafts, which is being carried out at the Moscow Aviation Institute. This system is based on superconducting electrical machines, cryoelectronic and a hydrogen cooling system. The main difficulties on the way of creating HEPS are described. The schemes of the developed superconducting electrical machines with high specific power are presented. A diagram of one of the variants of the electric propulsion system for future aircraft based on superconducting components is illustrated. The features of HEPS simulation and its cooling system modelling are described. Some results of Hydrogen Electric Propulsion System components development are discussed.
25 December 2017 in IEEE Transactions on Applied Superconductivity
The concept of the more electric aircraft and fully electric aircraft implies the development of a fully new energy system. An ironless fully superconducting machine with outer ferromagnetic shield looks very promising due to high critical currents and low losses. This paper presents the results of the analytical calculation of the specific power for different power ranges and rotation speeds. Finite element modeling was used for verifying and clarifying the results of the analytical solution. The developed method of combining analytical solutions and numerical simulations allows us to determine the highest power density of the machine. It can be extremely useful at the first stage of the design research of the new type of machines without iron cores as well as for the design and optimization of the machines' magnetic circuit for different numbers of pole pairs, stator, and rotor dimensions, HTS critical currents, and operation times.
1 June 2020 in Journal of Physics: Conference Series
The article discusses the advantages of using liquid hydrogen to cool superconducting electric machines for an all-electric aircraft. Calculation schemes and basic parameters of superconducting electric machines with liquid hydrogen cooling are presented. It is shown that liquid hydrogen is practically a non-alternative type of fuel for future electric aircraft because of its high energy intensity and environmental cleanliness.
10 January 2022 in EUREKA: Physics and Engineering
The use of liquid hydrogen as a fuel will be inevitable in the aviation of the future. This statement means that manufacturers will also implement liquid hydrogen for cooling all superconducting aviation equipment of an electric propulsion system. The development of fully electric aircraft is the most promising solution in this case. Scientists from the Department of electrical machines and power electronics of Moscow aviation institute have conducted calculations and theoretical researches of critical specific mass-dimensional parameters (MW/ton and MW/m3 at 21 K) of fully superconducting aviation synchronous generator of the electric propulsion system. The results are in this article. The article discusses the results 3D finite element modeling (FEM) simulation of a 5 MW fully superconducting synchronous generator with combined excitation. Superconducting armature and axial excitation windings based on second generation high temperature superconductors (HTS-2G) are located on the stator, which makes it possible to contactlessness and the absence of sliding seals. A dry gap will reduce gas-dynamic losses and increase the nominal peripheral speed of the rotor. The use of liquid hydrogen as a coolant makes it possible to significantly increase the linear load of the generator, and high current densities to reduce the cross-sectional area of the coils, which will make it possible to place them in individual cryostats in the future. Individual cryostats will allow to remove the heat release of magnetic losses from the cryogenic zone and reduce the consumption of refrigerant. For the purpose of internal redundancy of the HTS coils, the machine has a complete set of reserve winding made of ultrapure aluminum, also cooled by liquid hydrogen. If the superconducting coils get out of the stand, the generator will provide 15 % power on standby
19 October 2017 in IOP Conference Series: Earth and Environmental Science