Porosity, permeability, and wettability are crucial factors that affect the oil–water displacement process in reservoirs. Under subsurface conditions, the integral effects of these factors are extremely difficult to document. In this paper, waterflooding experiments were carried out using a core flooding system monitored with X-ray dual-energy CT. The mesoscale, three-dimensional characteristics of water displacing oil were obtained in real time. The integral effects of porosity, permeability, and wettability on the waterflooding in the low-permeability sandstone reservoirs were investigated. It was found that if the reservoir rock is water-wet, then the residual oil saturation decreases gradually with increasing porosity and permeability, showing an increasing waterflooding efficiency. On the contrary, if the reservoir rock is oil-wet, the residual oil saturation gradually increases with improving porosity and permeability, showing a decreasing waterflooding efficiency. The porosity, permeability, and wettability characteristics of reservoirs should be comprehensively evaluated before adopting technical countermeasures of waterflooding or wettability modification during oilfield development. If the porosity and permeability of the reservoir are high, water-wet reservoirs can be directly developed with waterflooding. However, it is better to make wettability modifications first before the waterflooding for oil-wet reservoirs. If the porosity and permeability of the reservoir are poor, direct waterflooding development has a better effect on oil-wet reservoirs compared with the water-wet reservoirs.
The eastern Kuqa Depression in the northern Tarim Basin, NW China, is rich in oil and gas. However, recent exploration has been hindered by a lack of knowledge on the evolution of the petroleum system. To address this, we conducted hydrocarbon generation and accumulation modeling using both the 2Dmove and PetroMod2017 software for a complex tectonic extrusion section in the Kuqa Depression. The results show that the source rocks in the northern slope zone became mature quite early at around 170 Ma, but the thermal maturity evolution stagnated subsequently because of tectonic extrusion and uplift. The source rocks in the central anticline zone, the southern slope zone, and the deep sag zone were of overall low maturity during the Jurassic to Paleogene but rapidly became mature to highly mature with the deposition of the Neogene Jidike and Kangcun formations. The main hydrocarbon generation periods are in the late Neogene and Quaternary, and the main hydrocarbon generation stratum is the lower Jurassic Yangxia formation. The amount of cumulative hydrocarbon generation gradually increases for carbonaceous mudstone, mudstone, and coal source rocks. Sourced from source rocks mainly in the northern slope zone, oil and gas migrated to anticlinal traps along sandstone transport layers and faults. Recent discoveries, such as the Tudong-2 gas field in the central anticline zone, underscore the richness of this region in petroleum resources. Some gas fields were also predicted in lithologic traps in the southern slope zone and the deep sag zone, as well as in fault-related traps in the northern part of the northern slope zone.
The Dibei Gas Field, located in the northern Kuqa Foreland Basin, Tarim Basin, western China, is one of the most important condensate gas-producing areas in China, with over one trillion cubic feet of gas reserves discovered in the Jurassic terrestrial reservoirs. However, further hydrocarbon exploration and development in the area is hampered by uncertainties on the petroleum sources. A robust oil–source and gas-source correlation analysis was carried out in the Dibei area to enhance our understanding of the gas accumulation potential. An integrated molecular geochemical analysis, multivariate analysis, and basin modeling were conducted to investigate source rocks, inclusion oils, reservoir oils, and gas from the Dibei area. Two types of source rocks have been identified in the Dibei area: a Jurassic coaly source rock and a Triassic lacustrine source rock based on multivariate analysis. The compositions of the n-alkanes, steranes, and terpanes and the carbon isotope ratios of individual n-alkanes in the inclusion oil extracts and reservoir oils from Jurassic Yangxia and Ahe reservoirs show distinct differences when compared with the two types of source extracts. Multiple oil sources are revealed in the Dibei area, with various degrees of mixing between reservoir oil (present) and inclusion oil (paleo), reflecting evolving oil sources. Basin modeling shows that during the late Himalayan orogeny, the Jurassic strata in the Dibei area experienced a rapid burial within ~20 Ma, with the oil generation window of the source rocks expanding greatly. This caused the shallowly buried Jurassic source rocks to enter the oil generation window, resulting in the occurrence of two oil sources for the inclusion oils and reservoir oils, and an increasing degree of mixing over time. Our finding confirms that the accumulated condensate gas in the Dibei area is mainly derived from the Jurassic source rocks. This allows the extent of prospective exploration to be better defined.
With the continuous advancement of oil and gas exploration technologies and associated theoretical frameworks, deep to ultra-deep oil and gas exploration has emerged as a pivotal component of contemporary petroleum geology research and currently seems as a focal area of interest. But, overpressure is prevalent in deep to ultra-deep formations, and there are substantial discrepancies in studies regarding the impact of overpressure on the maturity of hydrocarbon source rocks and hydrocarbon generation. These discrepancies have hindered a comprehensive understanding of hydrocarbon formation and phase states in ultra-deep settings, thereby constraining deep oil and gas exploration endeavors.The Shawan Sag in the Junggar Basin is characterized by widespread and high-intensity overpressure development, coupled with huge hydrocarbon resources in the lower stratigraphic assemblage. Among these, The Fengcheng Formation, serving as the primary hydrocarbon source rock, is the main source of oil and gas for the reservoirs within the sag. Consequently, this study focuses on the Permian hydrocarbon source rocks in the Shawan Sag of the Junggar Basin as the primary research target. After ascertaining the overpressure development in the Permian strata, typical low-maturity samples were selected to conduct hydrocarbon generation physical simulation experiments under varying pressure conditions. Based on these experiments, maturity evolution and hydrocarbon generation kinetic models that account for pressure were established, and thermal-maturity-hydrocarbon generation evolutionary history simulations were performed for typical wells and a 2D cross-section.The results reveal the following: (1) There is a negative correlation between vitrinite reflectance and pressure in the vertical direction, with Ro evolution being lower than the normal trend in overpressure zones. (2) Thermal simulation experiments confirm that, under identical temperature conditions, higher pressure leads to a lower equivalent Ro and a greater proportion of medium-to-heavy components in the generated hydrocarbon products, demonstrating the inhibitory effect of pressure on hydrocarbon source rock maturity and hydrocarbon generation products. (3) Based on the results of physical simulation experiments and measured geological data, a 2D thermal-maturity-hydrocarbon generation evolutionary history for the Shawan Sag was simulated. It is concluded that the hydrocarbon source rocks in the Fengcheng Formation of the Shawan Sag are predominantly Type II highly mature hydrocarbon source rocks. The hydrocarbon generation threshold is suppressed until the end of the Triassic, with significant oil generation commencing in the late Jurassic and entering the highly mature stage by the end of the Cretaceous. Regarding hydrocarbon generation products, the cracking of heavy hydrocarbons to generate gas in the Fengcheng Formation is inhibited by overpressure. This study contributes to enhancing the theoretical understanding of overpressure-inhibited hydrocarbon generation and holds practical significance for hydrocarbon exploration in ultra-deep formations within the Shawan Sag.