This work discusses the design and demonstration of an in-situ test setup for testing pipeline steels in a high pressure gaseous hydrogen (H₂) environment. A miniature hollow pipe-like tensile specimen was designed that acts as the gas containment volume during the test. Specific areas of the specimen can be forced to fracture by selective notching, as performed on the weldment. The volume of H₂ used was minimised so the test can be performed safely without the need of specialised equipment. The setup is shown to be capable of characterising Hydrogen Embrittlement (HE) in steels through testing an X60 pipeline steel and its weldment. The percentage elongation (%El) of the base metal was found to be reduced by 40% when tested in 100 barg H₂. Reduction of cross-sectional area (%RA) was found to decrease by 28% and 11% in the base metal and weld metal, respectively, when tested in 100 barg H₂. Benchmark test were performed at 100 barg N₂ pressure. SEM fractography further indicated a shift from normal ductile fracture mechanisms to a brittle transgranular (TG) quasi-cleavage (QC) type fracture that is characteristic of HE.

In this work, the hydrogen fatigue of pipeline steel X60, its girth welds and weld defects were investigated through in situ fatigue testing. A novel in situ gaseous hydrogen charging fatigue set-up was developed, which involves a sample geometry that mimics a small-scale pipeline with high internal hydrogen gas pressure. The effect of hydrogen was investigated by measuring the crack initiation and growth, using a direct current potential drop (DCPD) set-up, which probes the outer surface of the specimen. The base and weld metal specimens both experienced a reduction in fatigue life in the presence of hydrogen. For the base metal, the reduction in fatigue life manifested solely in the crack growth phase; hydrogen accelerated the crack growth by a factor of 4. The crack growth rate for the weld metal accelerated by a factor of 8. However, in contrast to the base metal, the weld metal also experienced a reduction of 57% in resistance to crack initiation. Macropores (>500 µm in size) on the notch surface reduced the fatigue life by a factor of 11. Varying the pressure from 70 barg to 150 barg of hydrogen caused no difference in the hydrogen fatigue behavior of the weld metal. The fracture path of the base and weld metal transitioned from transgranular and ductile in nature to a mixed-mode transgranular and intergranular quasi-cleavage fracture. Hydrogen accelerated the crack growth by decreasing the roughness- and plasticity-induced crack closure. The worst case scenario for pipelines was found in the case of weld defects. This work therefore highlights the necessity to re-evaluate pipelines for existing defects before they can be reused for hydrogen transport.

The DNVGL method is widely known for calculating the collapse pressure for pipes that are designed to operate at very great depths of the ocean. Such pipes are regarded as quite thick-walled with diameter to wall thickness ratios in the range 15 \< D/t\<30. There is now substantial experience in the practical design, installation and operation of such pipes. Recently