Recently, a significant amount of research has been devoted to soft robots. Artificial muscles belong to the most important components of soft robots. Dielectric elastomer actuators (DEAs) represent the technology that comes closest to the capabilities of a natural muscle, making them the best candidates for artificial muscles in robotics and prosthetics applications. To develop these applications, an analysis of DEAs in a test bench must be possible. It is important that the environmental conditions are known, and all components are specified, which is not the case in most publications. This paper focuses on the development of a real-time test bench for DEAs which provides environmental conditions and all components that are specified. Its goal is to open up the research field of dielectric elastomer actuators or soft robots. The stacked DEA used is powered by a high-voltage amplifier, which can be controlled via a real-time block diagram environment together with a data acquisition (DAQ) device. The response of the actuator is measured with a laser triangulation sensor. Furthermore, information about the applied voltage, the operating current, the temperature, and the humidity are collected. It was demonstrated that the selected laser sensor is a suitable device for this application. Moreover, it was shown that the selected high-voltage amplifier is adequate to power a DEA. However, the DAQ is not fast enough to measure the actuator current. It was demonstrated that housing keeps environmental conditions constant, is transportable, and offers the flexibility to investigate different DEAs.

To fully harness the potential of dielectric elastomer actuators (DEAs) in soft robots, advanced control methods are needed. An important groundwork for this is the development of a control-oriented model that can adequately describe the underlying dynamics of a DEA. Existing models commonly focus on custom-made DEAs, simplifying the modelling process due to well-known specifications and actuator structures. However, for commercial actuators, only information from the manufacturer is available, necessitating verification or completion during the modelling process. The aim of this paper is to explore how a commercial stacked silicone-based DEA can be modelled and how complex the model should be to properly replicate the features of the actuator. The static description has demonstrated the suitability of Hooke’s law. In the case of dynamic description, it is shown that no viscoelastic model is needed for control-oriented modelling. However, if all features of the DEA are considered, the generalised Kelvin–Maxwell model with three Maxwell elements shows good results, stability and computational efficiency.

In order to fully harness the potential of dielectric elastomer actu-ators (DEAs) in soft robots, advanced control methods are need-ed. An important groundwork for this is the development of a control-oriented model that can adequately describe the underly-ing dynamics of a DEA. A common feature of existing models is that always custom-made DEAs were investigated. This makes the modelling process easier, as all specifications and the struc-ture of the actuator are well known. In the case of a commercial actuator, however, only the information from the manufacturer is available and must be checked or completed during the modelling process. The aim of this paper is to explore how a commercial stacked silicone-based DEA can be modelled and how complex the model should be to properly replicate the features of the actu-ator. The static description has demonstrated the suitability of Hooke's law. In the case of dynamic description, it is shown that no viscoelastic model is needed for control-oriented modelling. However, if all features of the DEA are considered, the general-ized Kelvin-Maxwell model with three Maxwell elements shows good results, stability and computational efficiency.