This article describes a method for the real-time monitoring of the current consumed by a Dynamixel MX 64 AT servomotor used in the actuation system of modular mobile robotic platforms having differential locomotion and conventional wheels. The data acquisition method is based on an Arduino Mega 2560 development board interfaced with Matlab Simulink and the ASC712-5A hall sensor for current detection. A Simulink model is presented that performs the detection of a sensor reference voltage, which needs to be calibrated for a correct reading of the current. Due to the low resolution of the analog-to-digital converter with which the Arduino Mega is equipped, current monitoring is difficult to achieve, having large fluctuations and a lower resolution than the current absorbed by the servomotor. The solution to this problem is achieved by implementing, in the hardware construction, an ADS115 conversion module with 16-bit resolution, which leads to an increase in the measurement range of the ASC712-5A sensor. The current acquisition model with the Hall sensor is experimentally validated using measurements on the physical model of the drive wheel. This article further deals with the CAD and digital block modeling of mobile platforms with four and two wheels. The dynamic model of the robot is created in the Simulink–Simscape–Multibody environment and is used to determine the servomotor torques when the robot is moving along the predefined path. The torque variations are entered as variables in the Simulink digital block model of the robot. The Simulink model is simulated when moving along a square path, which determines the variation in the current absorbed by the motors. Experimental validation of the model is carried out using measurements on the functional models that operate in real conditions. A power consumption method is further proposed.