Zakria Ghazanfar Toor

Dr. Zakria Ghazanfar Toor

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2019
Verified
Conference Paper
Closed access
BMBilal Mufti
Bilal Mufti
TKT.I. Khan
T.I. Khan
JMJ. Masud
J. Masud
ZTZakria Ghazanfar Toor
Zakria Ghazanfar Toor
The understanding of the flow field in the vicinity of fuselage/air inlet integration area and inside air intake is important for performance estimation of an air intake-propulsion system combination. In this paper flow field simulation of a Diverterless Supersonic Inlet (DSI) is carried out using Embedded LES (ELES) methodology. Zonal embedded mesh strategy is devised to resolve the integral length scale in LES zone. The analysis is carried out at a subsonic Mach number $\mathbf{M}_{\infty}=\mathbf{0 . 8}$ and a supersonic Mach number $\mathbf{M}_{\infty}=\mathbf{1 . 53}$. For each Mach number analysis is initially carried out at a design mass flow rate condition, flow field variations are subsequently analyzed for low and high mass flow rate conditions. Flow field is analyzed to ascertain the quality of flow exiting the air intake duct and entering engine. The existence of turbulent vortical structures formed inside duct due to wall shear effects is observed. The duct curvature adds an inherent swirl to the flow. Secondary flow structure at engine face plane remains relatively uniform at low and design mass flow rates for both subsonic and supersonic conditions. At high mass flow rate condition the secondary flow structure loses its uniformity with an increase in swirl magnitude. The shockwave structure on the bump compression surface is also effectively captured using the ELES methodology. The subsonic and supersonic total pressure recovery characteristic computed using ELES methodology showed agreement when compared with wind tunnel data.

23 March 2023 in Lubricants
Verified
Journal Article
Open access
PDF file
RBRached Ben-Mansour
Rached Ben-Mansour
HRHamza Raza
Hamza Raza
ZTZakria Ghazanfar Toor
Zakria Ghazanfar Toor
With recent advancements in the petroleum industry, the need for multiphase pumps to transport multiphase products, such as the product of oil, water, and natural gas, arises along with their challenges. A helico-axial multiphase pump should be capable of converting fluid kinetic energy into pressure by avoiding gas–liquid separation and the gas-locking phenomenon, enabling smooth pump operation at higher gas volume fractions. In this paper, erosion on a helico-axial pump is evaluated at different flow conditions using sand particles mixed with water. A very important practical finding of this investigation is that the erosion rate increased when the flow conditions deviated from the design point of 3600 RPM. Operating the pump in off-design conditions not only reduced its hydraulic efficiency but also increased the erosion rates and hence reduces its life. It was observed that at 4800 RPM, the pump efficiency decreased by 11% and the erosion rate increased by 80%. This increase in erosion rate was attributed to the formation of local vortices upstream of the blade leading edge affecting the particle flow path and increasing its impact on the blade surface.