This paper describes a finite element analysis (FEA) and design of cold-formed steel built-up closed sections with intermediate stiffeners in the flange and web under axial compression. A finite element model (FEM) was developed and validated using the available experimental results. The validated FEM can be used for further parametric study on strength of built-up closed columns. The results obtained from the parametric study are compared with the current direct strength method (DSM) in the North American specification of cold-formed steel structures for those specimens that failed by only local, distortional, and flexural buckling. It is shown that the current DSM is not quite suitable for the design of cold-formed steel built-up closed columns. Therefore, the improved design equations are proposed by modifying the current design equations used in the DSM for flexural, local, and distortional buckling. The reliability of current DSM and proposed DSM was assessed by reliability analysis.
31 May 2017 in Arabian Journal for Science and Engineering
This paper investigates the axial-compression capacity of cold-formed steel (CFS) equal angle sections with complex edge stiffeners. Both experimental and numerical analyses were carried out. In total, 10 tests were carried out and the results are presented in this paper. Preceding to compression tests, the material properties were determined and initial geometric imperfections of all the test specimens were measured. From the results of compression tests, the specimens were all susceptible to flexural buckling. A numerical model was created using the finite-element (FE) software ABAQUS version 6.11. The results of finite-element analysis (FEA) substantiated with the experimental results. The FE models were found to accurately predict the experimental behavior. Thus, the validated FE models were used for a parametric study to analyze the effect of slenderness ratio and the orientation of edge stiffeners on the axial capacity. The axial strengths obtained from parametric study were compared with the design strengths calculated by the direct strength method (DSM) from the American Iron and Steel Institute (AISI) specification. Upon comparison, it was found that the axial strengths calculated based on the current DSM are overconservative by 58% on an average.
15 July 2019 in Asian Journal of Civil Engineering
In the current study, polypropylene and steel hybrid fiber reinforced self-compacting concrete was analyzed with and without the introduction of carbon nanotubes. A range of workability and hardened properties studies was performed along with the adsorption characteristics. Three different weight fractions including 15, 20, 25 kg/m3 for polypropylene fiber and 3,6,9 kg/m3 of steel fibres were individually and combinedly added. Also, with a fixed volume of 0.4% of carbon nanotubes, the behaviour of SCC was analyzed. To evaluate the fresh properties of Hybrid Fiber Reinforced Self-Compacting Concrete (HFRSCC), V-Funnel, slump-flow and L-box tests were performed. Result reveals that steel fiber and hybrid fiber added self-compacting concrete provides enhanced hardened properties than the polypropylene fiber SCC. Also, the result revealed that with the CNT incorporation, the hardened strength properties were enhanced and however the workability characteristics diminished.