Mapping and monitoring of forest carbon stocks across large areas in the tropics will necessarily rely on remote sensing approaches, which in turn depend on field estimates of biomass for calibration and validation purposes. Here, we used field plot data collected in a tropical moist forest in the central Amazon to gain a better understanding of the uncertainty associated with plot-level biomass estimates obtained specifically for the calibration of remote sensing measurements. In addition to accounting for sources of error that would be normally expected in conventional biomass estimates (e.g., measurement and allometric errors), we examined two sources of uncertainty that are specific to the calibration process and should be taken into account in most remote sensing studies: the error resulting from spatial disagreement between field and remote sensing measurements (i.e., co-location error), and the error introduced when accounting for temporal differences in data acquisition. We found that the overall uncertainty in the field biomass was typically 25% for both secondary and primary forests, but ranged from 16 to 53%. Co-location and temporal errors accounted for a large fraction of the total variance (>65%) and were identified as important targets for reducing uncertainty in studies relating tropical forest biomass to remotely sensed data. Although measurement and allometric errors were relatively unimportant when considered alone, combined they accounted for roughly 30% of the total variance on average and should not be ignored. Our results suggest that a thorough understanding of the sources of error associated with field-measured plot-level biomass estimates in tropical forests is critical to determine confidence in remote sensing estimates of carbon stocks and fluxes, and to develop strategies for reducing the overall uncertainty of remote sensing approaches.

Changes in tropical-forest structure and aboveground biomass (AGB) contribute directly to atmospheric changes in CO${}_2$ , which, in turn, bear on global climate. This paper demonstrates the capability of radar-interferometric phase-height time series at X-band (wavelength = 3 cm) to monitor changes in vertical structure and AGB, with sub-hectare and monthly spatial and temporal resolution, respectively. The phase-height observation is described, with a focus on how it is related to vegetation-density, radar-power vertical profiles, and mean canopy heights, which are, in turn, related to AGB. The study site covers $18\times 60$ km in the Tapajós National Forest in the Brazilian Amazon. Phase-heights over Tapajós were measured by DLR’s TanDEM-X radar interferometer 32 times in a 3.2 year period from 2011–2014. Fieldwork was done on 78 secondary and primary forest plots. In the absence of disturbance, rates of change of phase-height for the 78 plots were estimated by fitting the phase-heights to time with a linear model. Phase-height time series for the disturbed plots were fit to the logistic function to track jumps in phase-height. The epochs of clearing for the disturbed plots were identified with ≈1-month accuracy. The size of the phase-height change due to disturbance was estimated with ≈2-m accuracy. The monthly time resolution will facilitate REDD+ monitoring. Phase-height rates of change were shown to correlate with LiDAR RH90 height rates taken over a subset of the TanDEM-X data’s time span (2012–2013). The average rate of change of phase-height across all 78 plots was 0.5 m-yr ${}^{-1}$ with a standard deviation of 0.6 m-yr ${}^{-1}$ . For 42 secondary forest plots, the average rate of change of phase-height was 0.8 m-yr ${}^{-1}$ with a standard deviation of 0.6 m-yr ${}^{-1}$ . For 36 primary forest plots, the average phase-height rate was 0.1 m-yr ${}^{-1}$ with a standard deviation of 0.5 m-yr ${}^{-1}$ . A method for converting phase-height rates to AGB-rates of change was developed using previously measured phase-heights and field-estimated AGB. For all 78 plots, the average AGB-rate was 1.7 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ with a standard deviation of 4.0 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ . The secondary-plot average AGB-rate was 2.1 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ , with a standard deviation of 2.4 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ . For primary plots, the AGB average rate was 1.1 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ with a standard deviation of 5.2 Mg-ha ${}^{-1}$ -yr ${}^{-1}$ . Given the standard deviations and the number of plots in each category, rates in secondary forests and all forests were significantly different from zero; rates in primary forests were consistent with zero. AGB-rates were compared to change models for Tapajós and to LiDAR-based change measurements in other tropical forests. Strategies for improving AGB dynamical monitoring with X-band interferometry are discussed.

Digital aerial photogrammetry (DAP) data acquired by unmanned aerial vehicles (UAV) have been increasingly used for forest inventory and monitoring. In this study, we evaluated the potential of UAV photogrammetry data to detect individual trees, estimate their heights (ht), and monitor the initial silvicultural quality of a 1.5-year-old Eucalyptus sp. stand in northeastern Brazil. DAP estimates were compared with accurate tree locations obtained with real time kinematic (RTK) positioning and direct height measurements obtained in the field. In addition, we assessed the quality of a DAP-UAV digital terrain model (DTM) derived using an alternative ground classification approach and investigated its performance in the retrieval of individual tree attributes. The DTM built for the stand presented an RMSE of 0.099 m relative to the RTK measurements, showing no bias. The normalized 3D point cloud enabled the identification of over 95% of the stand trees and the estimation of their heights with an RMSE of 0.36 m (11%). However, ht was systematically underestimated, with a bias of 0.22 m (6.7%). A linear regression model, was fitted to estimate tree height from a maximum height metric derived from the point cloud reduced the RMSE by 20%. An assessment of uniformity indices calculated from both field and DAP heights showed no statistical difference. The results suggest that products derived from DAP-UAV may be used to generate accurate DTMs in young Eucalyptus sp. stands, detect individual trees, estimate ht, and determine stand uniformity with the same level of accuracy obtained in traditional forest inventories.

The unavoidable diet change in emerging countries, projected for the coming years, will significantly increase the global consumption of animal protein. It is expected that Brazilian livestock production, responsible for close to 15% of global production, be prepared to answer to the increasing demand of beef. Consequently, the evaluation of pasture quality at regional scale is important to inform public policies towards a rational land use strategy directed to improve livestock productivity in the country. Our hypothesis is that MODIS images can be used to evaluate the processes of degradation, restoration and renovation of tropical pastures. To test this hypothesis, two field campaigns were performed covering a route of approximately 40,000 km through nine Brazilian states. To characterize the sampled pastures, biophysical parameters were measured and observations about the pastures, the adopted management and the landscape were collected. Each sampled pasture was evaluated using a time series of MODIS EVI2 images from 2000–2012, according to a new protocol based on seven phenological metrics, 14 Boolean criteria and two numerical criteria. The theoretical basis of this protocol was derived from interviews with producers and livestock experts during a third field campaign. The analysis of the MODIS EVI2 time series provided valuable historical information on the type of intervention and on the biological degradation process of the sampled pastures. Of the 782 pastures sampled, 26.6% experienced some type of intervention, 19.1% were under biological degradation, and 54.3% presented neither intervention nor trend of biomass decrease during the period analyzed.

Knowing the aboveground biomass (AGB) stock of tropical forests is one of the main requirements to guide programs for reducing emissions from deforestation and forest degradation (REDD+). Traditional 3D products generated with digital aerial photogrammetry (DAP) have shown great potential in estimating AGB, tree density, diameter at breast height, height, and basal area in forest ecosystems. However, these traditional products explore only a small part of the structural information contained in the 3D data, thus not leveraging the full potential of the data for inventory purposes. In this study, we tested the performance of 3D products derived from DAP and a technique based on Fourier transforms of vertical profiles of vegetation to estimate AGB, tree density, diameter at breast height, height, and basal area in a secondary fragment of Atlantic Forest located in northeast Brazil. Field measurements were taken in 30 permanent plots (0.25 ha each) to estimate AGB. At the time of the inventory, we also performed a digital aerial mapping of the entire forest fragment with an unmanned aerial vehicle (UAV). Based on the 3D point clouds and the digital terrain model (DTM) obtained by DAP, vertical vegetation profiles were produced for each plot. Using traditional structure metrics and metrics derived from Fourier transforms of profiles, regression models were fit to estimate AGB, tree density, diameter at breast height, height, and basal area. The 3D DAP point clouds represented the forest canopy with a high level of detail, regardless of the vegetation density. The metrics based on the Fourier transform of profiles were selected as predictors in all models produced. The best model for AGB explained 93% (R${}^2$ = 0.93) of the biomass variation at the plot level, with an RMS error of 9.3 Mg ha${}^{-1}$ (22.5%). Similar results were obtained in the models fit for the tree density, diameter at breast height, height, and basal area, with R${}^2$ values above 0.90 and RMS errors of less than 18%. The use of Fourier transforms of profiles with 3D products obtained by DAP demonstrated a high potential for estimating AGB and other forest variables of interest in secondary tropical forests, highlighting the value of UAV as a low-cost tool to assist the implementation of REDD+ projects in developing countries like Brazil.

Tropical forests have high species richness, being considered the most diverse and complex ecosystems in the world. Research on the variation and maintenance of biodiversity in these ecosystems is important for establishing conservation strategies. The main objective of this study was to test the Spectral Variation Hypothesis through associations between species diversity and richness measured in the field and hyperspectral data collected by a Remotely Piloted Aircraft (RPA) in areas with secondary tropical forest in the Brazilian Atlantic Forest biome. Specific objectives were to determine which dispersion measurements, standard deviation (SD) or coefficient of variation (CV), estimated for the n pixels occurring within each sampling unit, better explains species diversity; the effects of pixel size on the direction and intensity of this relationship; and the effects of shaded pixels within each sampling unit. The spectral variability hypothesis was confirmed for the Atlantic Forest biome, with R² of 0.83 for species richness and 0.76 and 0.69 for the Shannon and Simpson diversity indices, respectively, using 1.0 m illuminated pixels. The dispersion (CV and SD) of hyperspectral bands were most strongly correlated with taxonomic diversity and richness in the red-edge and near-infrared (NIR) regions of the electromagnetic spectrum. Pixel size affected R² values, which were higher for 1.0 m pixels (0.83) and lower for 10.0 m pixels (0.71). Additionally, illuminated pixels had higher R² values than those under shadow effects. The main dispersion variables selected as metrics for regression models were mean CV, CV for the 726.7 nm band, and SD for the 742.3 and 933.4 nm bands. Our results suggest that spectral diversity can serve as a proxy for species diversity in the Atlantic Forest. However, factors that can affect this relationship, such as taxonomic and spectral diversity metrics used, pixel size, and shadow effects in images, should be considered.