In order to improve the output characteristics of the electromagnetic energy harvester in a high-speed flow field, a spring-coupling electromagnetic energy harvester (SEGEH) is proposed, based on the galloping characteristics of a large amplitude. The electromechanical model of the SEGEH was established, the test prototype was made, and the experiments were conducted using a wind tunnel platform. The coupling spring can convert the vibration energy consumed by the vibration stroke of the bluff body without inducing an electromotive force into the elastic energy of the spring. This not only reduces the galloping amplitude, but it also provides elastic force for the return of the bluff body, and it improves the duty cycle of the induced electromotive force and the output power of the energy harvester. The stiffness of the coupling spring and the initial distance between the coupling spring and the bluff body will affect the output characteristics of the SEGEH. At a wind speed of 14 m/s, the output voltage was 103.2 mV and the output power was 0.79 mW. Compared with the energy harvester without a coupling spring (EGEH), the output voltage increases by 29.4 mV, with an increase of 39.8%. The output power was increased by 0.38 mW, with an increase of 92.7%.

The arrangement of the induction coil influences the electromagnetic damping force and output characteristics of electromagnetic energy harvesters. Based on the aforementioned information, this paper presents a proposal for a multiple off-center coil electromagnetic galloping energy harvester (MEGEH). This study establishes both a theoretical model and a physical model to research the influence of the position and quantity of the induction coils on the output characteristics of an energy harvester. Additionally, it conducts wind tunnel tests and analyzes the obtained results. With the increase in the number of induction coils, there is a significant improvement in the duty cycle and output power of the MEGEH, resulting in an amplified energy conversion efficiency. At a wind speed of 9 m/s, the duty ratios of a single set of coils (SC), two sets of coils (TC), and multiple sets of coils (MC) are 30%, 51%, and 100%, respectively. The total output powers are 0.4 mW, 0.62 mW, and 0.72 mW. However, the rate of output growth has decreased from 55% to 16%. The position of the coils affects the initial electromagnetic damping of the energy harvester. Changing the position can reduce the initial electromagnetic damping, thereby decreasing the critical wind speed. The critical wind speed of the MEGEH decreases as the induction coil is positioned further away from the vibration center. When the distance is sufficiently large, the electromagnetic damping force becomes negligible. When the induction coil is positioned centrally, the MEGEH demonstrates its maximum critical wind speed, which has been measured at 4.01 m/s. When the initial distance between the induction coil and the vibrating component is increased to 10 mm, the critical wind speed reaches its minimum value of 2.23 m/s. Therefore, it is necessary to optimize the arrangement of the coils. The coils of the MEGEH should be arranged with the MC and a 10 mm offset from the center.