This paper presents a dynamic modeling and control of doubly fed induction-generator (DFIG) based on the wind turbine systems. Active and reactive power control of the DFIG are based on the feedback technique by using the suitable voltage vectors on the rotor side. The rotor flux has no impact on the changes of the stator active and reactive power. The proposed controller is based on the feedback technique in order to reduce the oscillation of the generator. The control approach is estimated through the simulation result of the feedback controller assembled with DFIG wind turbines. It is applied by the feedback control based techniques in order to control the power flowing of DFIG and the power grid. Hence, an improved feedback control technique is adopted to get a better power flow transfer and to improve the dynamic system and transient stability. In stable condition, the improved performance of the controller, the proposed method is verified for the effectiveness of the control method is done in stable conditions

Electricity plays an important role in the socioeconomic growth and social prosperity of any country. It is to be considered as the basic need for human development. Nowadays, low production of electricity is a serious problem in Pakistan, which directly restricts the development of the state. One-third of Pakistan’s population does not have any electricity in the rural areas and about 10–12 hours load shedding in urban areas and is quite common. Although, the state of Pakistan always shows a deficit in the conventional resources, but no progress was also being made in the renewable resources such as the wind and solar energy. Therefore, it is better to utilize these natural assets in order to fulfill the electricity supply the country. In this manuscript, our main objective is to study and outlooks the country energy profile situation vis-à-vis wind energy potential characteristics of the most important wind corridor in the southern part of the country. Pakistan has around 1100 kilometers (km) coastal line for the wind energy potential, but in this manuscript, we have chosen one of the most suitable wind corridors of the southern part of the country. We also tried to prove theoretically that this wind zone is more favorable for country consumer demand. Moreover, future perspective and the major challenges during windmill implementation is also being discussed herein

In the modern era, distributed generation is considered as an alternative source for power generation. Especially, need of the time is to provide the three-phase loads with smooth sinusoidal voltages having fixed frequency and amplitude. A common solution is the integration of power electronics converters in the systems for connecting distributed generation systems to the stand-alone loads. Thus, the presence of suitable control techniques, in the power electronic converters, for robust stability, abrupt response, optimal tracking ability and error eradication are inevitable. A comprehensive review based on design, analysis, validation of the most suitable digital control techniques and the options available for the researchers for improving the power quality is presented in this paper with their pros and cons. Comparisons based on the cost, schemes, performance, modulation techniques and coordinates system are also presented. Finally, the paper describes the performance evaluation of the control schemes on a voltage source inverter (VSI) and proposes the different aspects to be considered for selecting a power electronics inverter topology, reference frames, filters, as well as control strategy.