We report the cooling-induced crystallization of layered two-dimensional (2D) lead halide perovskites with controllable inorganic quantum-well thicknesses (n = 1, 2, 3, and 4), organic-spacer chain lengths (butyl-, pentyl-, and hexylammonium), A-site cations (methylammonium and formamidinium), and halide anions (iodide and bromide). Using single-crystal X-ray diffraction, we refined crystal structures for the iodide family as a function of these compositional parameters and across their temperature-dependent phase transitions. In general, lower-symmetry crystal structures, increasing extents of organic-spacer interdigitation, and increasing organic-spacer corrugation tilts are observed at low temperature. Moreover, greater structural distortions are observed in lead halide octahedra closest to the organic-spacer layer, and higher-n structures exhibit periodic variation in Pb–I bond lengths. These structural trends are used to explain corresponding temperature-dependent changes in the photoluminescence spectra. We also provide detailed guidance regarding the combination of synthetic parameters needed to achieve phase-pure crystals of each composition and discuss difficulties encountered when trying to synthesize particular members of the 2D perovskite family containing formamidinium or cesium as the A-site cation. These results provide a foundation for understanding structural trends in 2D lead halide perovskites and the effects these trends have on their thermal, electronic, and optical properties.
25 September 2020 in The Journal of Physical Chemistry Letters
Addition of aqueous hydrohalic acids during the synthesis of colloidal quantum dots (QDs) is widely employed to achieve high‐quality QDs. However, this reliance on the use of aqueous solutions is incompatible with oxygen‐ and water‐sensitive precursors such as those used in the synthesis of Te‐alloyed ZnSe QDs. Herein, it is shown that this incompatibility leads to phase segregation into Te‐rich and Te‐poor regions, causing spectral broadening and luminescence peak shifting under high laser irradiation and applied electrical bias. Here, a synthetic strategy to produce anhydrous‐HF in situ by using benzenecarbonyl fluoride (BF) as a chemical additive is reported. Through in situ 19F NMR spectroscopy, it is found that BF reacts with surfactants in tandem, ultimately producing intermediary F···H···trioctylamine adducts. These act as a pseudo‐HF source that releases anhydrous HF. The controlled release of HF during nucleation and growth steps homogenizes Te distribution in ZnSeTe lattice, leading to spectrally stable blue‐emitting QDs under increasing laser flux from ≈3 µW to ≈12 mW and applied bias from 2.6 to 10 V. Single‐dot photoluminescence (PL) spectroscopy and analyses of the absorption, PL and transient absorption spectra together with density functional theory point to the role of anhydrous HF as a Te homogenizer.
21 November 2021 in Journal of the American Chemical Society
We report the low-frequency Raman spectrum (ω = 10 cm−1–150 cm−1) of a wide variety of alkylammonium iodide based 2D lead halide perovskites (2D LHPs) as a function of A-site cation (MA = methylammonium and FA = formamidinium), octahedral layer thickness (n = 2–4), organic spacer chain length (butyl-, pentyl-, hexyl-), and sample temperature (T = 77 K–293 K). Using density functional theory calculations under the harmonic approximation for n = 2 BA:MAPbI, we assign several longitudinal/transverse optical phonon modes between 30 cm−1 and 100 cm−1, the eigendisplacements of which are analogous to that observed previously for octahedral twists/distortions in bulk MAPbI. Additionally, we propose an alternative assignment for low-frequency modes below this band (<30 cm−1) as zone-folded longitudinal acoustic phonons corresponding to the periodicity of the entire layered structure. We compare measured spectra to predictions of the Rytov elastic continuum model for zone-folded dispersion in layered structures. Our results are consistent across the various 2D LHPs studied herein, with energetic shifts of optical phonons corresponding to microscopic structural differences between materials and energetic shifts of acoustic phonons according to changes in the periodicity and elastic properties of the perovskite/organic subphases. This study highlights the importance of both the local atomic order and the superlattice structure on the vibrational properties of layered 2D materials.