This study explores the effects of hybridization of glass fiber on low velocity impact behavior and damage tolerance capability of woven jute fabric composite. Laminates were fabricated by the hand lay—up technique using a mold and cured under light pressure at room temperature. Low velocity impact tests were conducted on jute and hybrid samples (150 × 150 mm) using an instrumented drop weight impact tower. All the samples were impacted at four different energy levels by changing the drop height, and load—energy—time plots were recorded using data acquisition software. Some of the samples were subjected to the non-destructive test (C-scan) to study the nature and extent of damage and to measure the delamination area. Post-impact tension tests were conducted to assess the damage tolerance capability of the composites. The results of the study indicated that jute laminates have better impact energy absorption capacity than jute—glass hybrid laminates; however their damage tolerance capability is less than jute—glass hybrid laminates.
In this paper, we report the use of the feedback signal of an ultrasonic fatigue system to dynamically deduce fatigue damage accumulation via changes in the nonlinear ultrasonic parameter. The applicability of this parameter in comparison to the resonant frequency for assessment of fatigue damage accumulation in a wrought aluminum alloy has been demonstrated, without the need for coupling fluids or independent generation of incident ultrasonic waves. The ultrasonic nonlinearity increased and the resonant frequency of the system decreased with initiation and propagation of the major crack. The nonlinear ultrasonic parameter shows greater sensitivity to damage accumulation than the resonant frequency. The number of cycles for crack propagation, estimated based on the changes in the nonlinear ultrasonic parameter, is in very good agreement with calculated crack growth rates based on the fractography studies.
Since the beginning of the applications of non-destructive testing/evaluation (NDT/NDE) techniques, efforts have been made consistently to improve their detection sensitivity and resolution. In the present paper, factors governing lateral resolution in three major NDT techniques, viz., ultrasonic testing (UT), x-ray radiographic testing (XRT), and eddy current testing (ECT) are presented. Furthermore, a review of recent advances in these NDT techniques to reach the theoretically achievable resolution limit or even surpassing the same using alternate approaches is also discussed. For example, resolution in UT is theoretically limited to half the wavelength by the Rayleigh limit; however, subwavelength resolutions have been achieved through the applications of near field methods by capturing the evanescent field. On the other hand, the resolution achieved in XRT is primarily limited to half the source/focal spot size, which is many orders of magnitude larger than the wavelength. Over the years, the reduction in the focal spot from macro-focus to micro-focus and now to nano-focus has led to improvement in the resolution to a few nanometers, of course, in combination with suitable magnification required due to detectors with limited pixel size (a few μm to a few 10 s of μm). Similarly, innovations in electromagnetic/magnetic sensors have significantly improved the resolution achieved in ECT. Atomic force microscopy, metamaterials, and artificial neural network-based methods have been employed for obtaining high-resolution NDE images. At the end, authors' perspective toward possible directions for high-resolution NDT is presented.