The proposal of this work was the preparation and characterization of activated carbons obtained from water treatment plant sludge (WTS) to apply as adsorbents in the removal of organic dye contaminants from wastewater. The activated carbons were produced with a combination of chemical activation and pyrolysis processes. The textural characteristics of both adsorbents presented a satisfactory superficial area and mesoporous structure. The presence of phenolic and carboxylic groups in the surface indicated a better adsorption of cationic adsorbates. When applied as adsorbents in the removal of methylene blue (MB) from wastewater, the maximum removal values obtained were up to 96%. The adsorption results showed that the adsorption was faster in the beginning and reached maximum around 30 min. The Elovich kinetic model and the Sips isotherm model presented the best fit to experimental data, which was checked by analysis of variance (ANOVA). The production of activated carbons from WTS is a sustainable and effective option in the removal of MB dye.
The study of the recovery of bioactive compounds from natural resources and its implications in several areas is very significant for the scientific community. This work aimed to study Brazilian agroindustrial wastes’ antioxidant and antimicrobial activities using green extraction. Olive leaves, jaboticaba peel, araçá peel, and pecan nut shells were evaluated under four conditions: (1) convective-drying and aqueous extraction, (2) convective-drying and ethanolic extraction, (3) freeze-drying and aqueous extraction, and (4) freeze-drying and ethanolic extraction. The results demonstrated that all samples showed high antioxidant potential, and the highest antioxidant activity was obtained for the extract of pecan nut shell. As for the quantification of compounds by HPLC, the olive leaf presented the highest content of phenolic compounds in the extract, mainly oleuropein. Finally, the antimicrobial activity analysis revealed the extracts’ bactericidal potential against Staphylococcus aureus and Escherichia coli. The present study shows that green extraction can extract bioactive compounds with antioxidant and antimicrobial properties, highlighting the importance of choosing the drying method and solvent for future uses of these natural resources by the industry.
In this article, the relationship between the properties of different membranes (agar, chitosan, and agar + chitosan) and biodegradability in natural and sterilized soil was investigated. The membranes under investigation exhibited variations in the biodegradation process, a phenomenon closely linked to both the soil microbiota composition and their water affinity. Higher solubility in water and greater swelling tendencies correlated with shorter initiation times for the biodegradation process in soil. Overall, all tested membranes began biodegradation within 14 days, as assessed through thickness and morphological analysis parameters, demonstrating a superior degradation rate compared to low-density polyethylene films.
In this study, ryegrass straw agricultural residue (Lolium multiflorum L.) was employed as an adsorbent material to remove methylene blue (MB) dye from aqueous solutions. Four adsorbents were produced using phosphoric acid and pyrolysis as activating agents. The samples were analyzed with TGA, FTIR, SEM, and XRD techniques. A rapid adsorption of the MB was obtained with the ryegrass treated with 40% H3PO4, reaching equilibrium in 2 min. Moreover, a maximum adsorption capacity of 80.79 mg g−1 and a removal efficiency of 99% were achieved. The results demonstrate a good performance of adsorbents from ryegrass for removing dye contaminants, such as methylene blue, from the aqueous solutions.
The food industry is responsible for the generation of large amounts of organic residues, which can lead to negative environmental and economic impacts when incorrectly disposed of. The jaboticaba peel is an example of organic waste, widely used in industry due to its organoleptic characteristcs. In this study, residues collected during the extraction of bioactive compounds from jaboticaba bark (JB) were chemically activated with H3PO4 and NaOH and used to develop a low-cost adsorbent material for the removal of the cationic dye methylene blue (MB). For all adsorbents, the batch tests were carried out with the adsorbent dosage of 0.5 g L−1 and neutral pH, previously determined by 22 factorial design. In the kinetics tests, JB and JB-NaOH presented a fast adsorption rate, reaching equilibrium in 30 min. For JB-H3PO4, the equilibrium was reached in 60 min. JB equilibrium data were best represented by the Langmuir model and JB-NaOH and JB-H3PO4 data by the Freundlich model. The maximum adsorption capacities from JB, JB-NaOH, and JB-H3PO4 were 305.81 mg g−1, 241.10 mg g−1, and 122.72 mg g−1, respectively. The results indicate that chemical activations promoted an increase in the volume of large pores but interacted with functional groups responsible for MB adsorption. Therefore, JB has the highest adsorption capacity, thus presenting as a low-cost and sustainable alternative to add value to the product, and it also contributes to water decontamination studies, resulting in a zero-waste approach.
In this research, the aim was to introduce innovation to the pharmaceutical field through the exploration of an underutilized plant matrix, the red araçá, along with the utilization of sodium alginate for the development of membranes designed for active topical dressings. Within this context, optimal extraction conditions were investigated using the central composite rotational statistical design (CCRD) to obtain a red araçá epicarp extract (RAEE) rich in bioactive compounds utilizing the maceration technique. The extract acquired under the optimized conditions (temperature of 66 °C and a hydroalcoholic solvent concentration of 32%) was incorporated into a sodium alginate matrix for the production of active membranes using a casting method. Characterization of the membranes revealed that the addition of the extract did not significantly alter its morphology. Furthermore, satisfactory results were observed regarding mechanical and barrier properties, as well as the controlled release of phenolic compounds in an environment simulating wound exudate. Based on these findings, the material produced from renewable matrices demonstrates the promising potential for application as a topical dressing within the pharmaceutical industry.