Endocrine-disrupting chemicals (EDCs) in the aquatic environment have garnered a lot of attention during the past few years. Due to their toxic behavior, which interferes with endocrine functions in both humans and aquatic species, these types of compounds have been recognized as major polluting agents in wastewater effluents. Therefore, the development of efficient and sustainable removal methods for these emerging contaminants is essential. Photocatalytic removal of emerging contaminants using silver carbonate (Ag2CO3)-based photocatalyst is a promising process due to the unique characteristics of this catalyst, such as absorption of a larger fraction of the solar spectrum, wide band gap, non-toxicity, and low cost. The photocatalytic performance of Ag2CO3 has recently been improved through the doping of elements and optimization variation of operational parameters resulting in decreasing the rate of electron–hole pair recombination and an increase in the semiconductor’s excitation state efficiency, which enables the degradation of contaminants under UV or visible light exposure. This review summarized some of the relevant investigations related to Ag2CO3-based photocatalytic materials for EDC removal from water. The inclusion of Ag2CO3-based photocatalytic materials in the water recovery procedure suggests that the creation of a cutting-edge protocol is essential for successfully eliminating EDCs from the ecosystem.
Zinc oxide (ZnO) micro and nanorods were successfully prepared using Pandanus amaryllifolius and hexamethylenetetramine (HMTA) separately as stabilizers using the solution immersion method. Two types of ZnO seed layer were prepared using the same pre-cursor with the different stabilizers. The fabricated ZnO microrods exhibit absorption at ~375 nm as revealed from the UV–Visible absorption spectrum, and this is comparable with ZnO nanorods synthesized using HMTA. X-ray diffraction (XRD) measurement displayed a sharp peak corresponding to the hexagonal wurtzite structure of ZnO microrods. Field emission scanning electron microscopy (FESEM) of ZnO microrods showed average diameter at approximately 500 nm compared to 70 nm of those synthesized from HMTA. A new finding is the ability of Pandanus amaryllifolius as a green stabilizer to grow a dense ZnO microrod structure with high crystallinity. Results reveal that both samples from different stabilizers during the preparation of the ZnO seed layer greatly improved the morphological and structural properties and optical absorption of ZnO. The main outcomes from this study will benefit optoelectronic application, such as in ultraviolet (UV) sensors.