We report on a novel implementation of the cryo-etching method, which enabled us to fabricate low-roughness hBN-encapsulated graphene nanoconstrictions with unprecedented control of the structure edges; the typical edge roughness is on the order of a few nanometers. We characterized the system by atomic force microscopy and used the measured parameters of the edge geometry in numerical simulations of the system conductance, which agree quantitatively with our low temperature transport measurements. The quality of our devices is confirmed by the observation of well defined quantized 2e2/h conductance steps at zero magnetic field. To the best of our knowledge, such an observation reports the clearest conductance quantization in physically etched graphene nanoconstrictions. The fabrication of such high quality systems and the scalability of the cryo-etching method opens a novel promising possibility of producing more complex truly-ballistic devices based on graphene.
27 June 2011 in IEEE Transactions on Nuclear Science
The Vertical Gradient Freeze (VGF) method has been used to grow high resistivity Cadmium Zinc Telluride (CZT) for high energy radiation applications. In this work, the effect of lapping and polishing the lateral edges of planar detectors is studied. Expectations that improved surface morphology of the edges should correlate with reduced surface leakage current are shown to be erroneous. The effect of various types of lateral edge treatments on detector performance was observed before and after each surface modification. Complementary results were obtained using I-V, Cathodoluminescence (CL), and gamma ray response measurements using 133Ba. As a result, a quick and easy method is reported which minimizes leakage current and actually enhances detector performance through the introduction of surface defects. It is demonstrated that the introduction of radiative recombination centers helps reduce surface leakage current in the detector by a factor of up to 200%, depending on the surface treatment. The purpose of this work is to identify material processing steps for fabricating planar devices based on CZT for gamma ray spectroscopy.