Tiangong-2, the second Chinese manned spacecraft, was launched into low Earth orbit on 15 September 2016. The dual-frequency geodetic GNSS receiver equipped on it is supporting a number of scientific experiments in orbit. This paper uses the onboard GNSS data from 3–31 December 2016 (in the attitude mode of three-axis Earth-pointing stabilization) to analyze the data quantity, as well as the code multipath error. Then, the dynamic and reduced-dynamic methods are adopted to perform the post Precise Orbit Determination (POD) based on the carrier phase measurements, respectively. After that, the orbit accuracy is evaluated using a number of tests, which include the analysis of observation residuals, Overlapping Orbit Differences (OODs), orbit comparison between dynamic and reduced-dynamic and Satellite Laser Ranging (SLR) validation. The results show that: (1) the average Root Mean Square (RMS) of the on-board GNSS phase fitting residuals is 8.8 mm; (2) regarding the OODs determined by the reduced-dynamic method, the average RMS in radial (R), along-track (T) and cross-track (N) directions is 0.43 cm, 1.34 cm and 0.39 cm, respectively, and there are no obvious system errors; (3) the orbit accuracy of TG02 determined by the reduced-dynamic method is comparable to that of the dynamic method, and the average RMS of their differences in R, T, N and 3D directions is 3.05 cm, 3.60 cm, 2.52 cm and 5.40 cm, respectively; (4) SLR data are used to validate the reduced-dynamic orbits, and the average RMS along the station-satellite direction is 1.94 cm. It can be seen that both of these two methods can meet the demands of 3D centimeter-level orbit determination for TG02.

High-precision orbits of Low Earth Orbit (LEO) satellites are essential for many scientific applications, such as assessing the change in current global mean sea level, estimating the coefficients of gravity field, and so on. How to determinate the high-precision orbits for LEO satellites has gradually become an important research focus. HY2D is a new altimetry satellite of China, which is equipped with a Global Positioning System (GPS) and the third generations of the BeiDou Global Navigation Satellite System (BDS-3) in order to guarantee the reliability of orbital precision in radar altimetry mission. Therefore, this study adopts one month of spaceborne data to conduct the research of precise orbit determination (POD) for the HY2D satellite. Our analysis results are: (1) The standard deviation of residuals for the HY2D satellite based on spaceborne BDS and GPS data are 9.12 mm and 8.53 mm, respectively, and there are no significant systematic errors in these residuals. (2) The comparison results with Doppler Orbitography and Radio-positioning Integrated by Satellite (DORIS)-derived orbits indicate that the HY2D satellite, using spaceborne BDS and GPS data, can achieve the radial accuracy of 1.4~1.5 cm, and the mean three-dimensional (3D) accuracy are 5.3 cm and 4.3 cm, respectively, which can satisfy high-precision altimetry applications. (3) By means of satellite laser ranging (SLR), the accuracy of Global Navigation Satellite System (GNSS)-derived orbits of HY2D is approximately 3.3 cm, which reflects that the model strategies are reliable.

GNSS real-time applications greatly benefit from the International GNSS Service’s (IGS) real-time service (RTS). This service does more than provide for terrestrial precise point positioning (PPP); it also brings more possibilities for space-borne technology. With this service, the State-Space Representation (SSR) product, which includes orbit corrections and clock corrections, is finally available to users. In this paper, the GPS real-time orbit and clock corrections provided by 11 analysis centers (ACs) from the day of the year (DOY) 144 to 153 of 2022 are discussed from 3 perspectives: integrity, continuity, and accuracy. Moreover, actual observation data from the GRACE-C satellite are processed, along with SSR corrections from different ACs. The following can be concluded: (1) In terms of integrity and continuity, the products provided by CNE, ESA, and GMV perform better. (2) CNE, ESA, and WHU are the most accurate, with values of about 5 cm for the satellite orbit and 20 ps for the satellite clock. Additionally, the clock accuracy is related to the Block. Block IIR and Block IIR-M are slightly worse than Block IIF and Block IIIA. (3) The accuracy of post-processing reduced-dynamic precise orbit determination (POD) and kinematic POD are at the centimeter level in radius, and the reduced-dynamic POD is more accurate and robust than the kinematic POD.

Satellite attitude modes and antenna phase center variations have a great influence on the Precise Orbit Determination (POD) of Low Earth Orbit satellites (LEOs). Inaccurate information about spacecraft attitude, phase center offsets and variations in the POD leads to orbital error. The Jason-3 satellite experienced complex attitude modes which are fixed, sinusoidal, ramp-up/down and yaw-flip. Therefore, it is necessary to properly construct the attitude model in the process of POD especially when there is no external attitude data. For the antenna phase center correction, the PCO which is the deviation between Antenna Reference Point (ARP) and Mean Antenna Phase Center (MAPC) usually can be calibrated on the ground accurately, but the PCV which is the deviation between Instantaneous Antenna Phase Center (IAPC) and Mean Antenna Phase Center (MAPC) will change greatly with the change of space environment. Residual approach can be used to estimate the receiver PCV map. In this paper, we collected the on-board GPS data of Jason-3 satellite from January 2019 and analyzed the impacts of PCV and spacecraft attitude on the orbit accuracy by performing the reduced-dynamic POD. Compared with the reference orbit released by the Centre National d'etudes Spatiales (CNES), using the PCV map can reduce the Root Mean Square (RMS) of orbit differences in the Radial (R), Along-track (T), Cross-track (N) and 3D direction about 0.3, 1.0, 0.9, and 1.4 mm. Based on the estimated PCV map, the orbit accuracy in R, T, N and 3D direction is 1.24, 2.81, 1.17, and 3.29 cm respectively by using the measured attitude data. When using the attitude model, the orbit accuracy in R, T, N and 3D directions is 1.60, 3.54, 1.33, and 4.13 cm, respectively. The results showed that the combination of measured attitude data and modeled PCV map can obtain the better orbit solution. It is essential to build a corresponding model in high-precision orbit determination, when there is no attitude data and PCV map.

Satellite laser ranging (SLR) observations provide an independent validation of the global navigation satellite system (GNSS) orbits derived using microwave measurements. SLR residuals have also proven to be an important indicator of orbit radial accuracy. In this study, SLR validation is conducted for the precise orbits of eight Galileo satellites covering four to eight years (the current longest span), provided by multiple analysis centers (ACs) participating in the multi-GNSS experiment (MGEX). The purpose of this long-term analysis (the longest such study to date), is to provide a comprehensive evaluation of orbit product quality, its influencing factors, and the effect of perturbation model updates on precise orbit determination (POD) processing. A conventional ECOM solar radiation pressure (SRP) model was used for POD. The results showed distinct periodic variations with angular arguments in the SRP model, implying certain defects in the ECOM system. Updated SRP descriptions, such as ECOM2 or the Box-Wing model, led to significant improvements in SLR residuals for orbital products from multiple ACs. The standard deviation of these residuals decreased from 8–10 cm, before the SRP update, to about 3 cm afterward. The systematic bias of the residuals was also reduced by 2–4 cm and the apparent variability decreased significantly. In addition, the effects of gradual SRP model updates in the POD were evident in orbit comparisons. Orbital differences between ACs in the radial direction were reduced from the initial 10 cm to better than 3 cm, which is consistent with the results of SLR residual analysis. These results suggest SLR validation to be a powerful technique for evaluating the quality of POD strategies in GNSS orbits. Furthermore, this study has demonstrated that perturbation models, such as SRP, provide a better orbit modeling for the Galileo satellites.

With the successful use of GPS-only-based POD (precise orbit determination), more and more satellites carry onboard GPS receivers to support their orbit accuracy requirements. It provides continuous GPS observations in high precision, and becomes an indispensable way to obtain the orbit of LEO satellites. Precise orbit determination of LEO satellites plays an important role for the application of LEO satellites. Numerous factors should be considered in the POD processing. In this paper, several factors that impact precise orbit determination are analyzed, namely the satellite altitude, the time-variable earth’s gravity field, the GPS satellite clock error and accelerometer observation. The GRACE satellites provide ideal platform to study the performance of factors for precise orbit determination using zero-difference GPS data. These factors are quantitatively analyzed on affecting the accuracy of dynamic orbit using GRACE observations from 2005 to 2011 by SHORDE software. The study indicates that: (1) with the altitude of the GRACE satellite is lowered from 480 km to 460 km in seven years, the 3D (three-dimension) position accuracy of GRACE satellite orbit is about 3∼4 cm based on long spans data; (2) the accelerometer data improves the 3D position accuracy of GRACE in about 1 cm; (3) the accuracy of zero-difference dynamic orbit is about 6 cm with the GPS satellite clock error products in 5 min sampling interval and can be raised to 4 cm, if the GPS satellite clock error products with 30 s sampling interval can be adopted. (4) the time-variable part of earth gravity field model improves the 3D position accuracy of GRACE in about 0.5∼1.5 cm. Based on this study, we quantitatively analyze the factors that affect precise orbit determination of LEO satellites. This study plays an important role to improve the accuracy of LEO satellites orbit determination.