We report on the lowest-frequency detection to date of three bursts from the fast radio burst FRB 180916.J0158+65, observed at 328 MHz with the Sardinia Radio Telescope (SRT). The SRT observed the periodic repeater FRB 180916.J0158+65 for five days from 2020 February 20 to 24 during a time interval of active radio bursting, and detected the three bursts during the first hour of observations; no more bursts were detected during the remaining ∼30 hr. Simultaneous SRT observations at 1548 MHz did not detect any bursts. Burst fluences are in the range 37 to 13 Jy ms. No relevant scattering is observed for these bursts. We also present the results of the multi-wavelength campaign we performed on FRB 180916.J0158+65, during the five days of the active window. Simultaneously with the SRT observations, others with different time spans were performed with the Northern Cross at 408 MHz, with XMM-Newton, NICER, INTEGRAL, AGILE, and with the TNG and two optical telescopes in Asiago, which are equipped with fast photometers. XMM-Newton obtained data simultaneously with the three bursts detected by the SRT, and determined a luminosity upper limit in the 0.3–10 keV energy range of ∼10⁴⁵ erg s⁻¹ for the burst emission. AGILE obtained data simultaneously with the first burst and determined a fluence upper limit in the MeV range for millisecond timescales of . Our results show that absorption from the circumburst medium does not significantly affect the emission from FRB 180916.J0158+65, thus limiting the possible presence of a superluminous supernova around the source, and indicate that a cutoff for the bursting mechanism, if present, must be at lower frequencies. Our multi-wavelength campaign sensitively constrains the broadband emission from FRB 180916.J0158+65, and provides the best limits so far for the electromagnetic response to the radio bursting of this remarkable source of fast radio bursts.

In this paper we present the electromagnetic modeling and beam pattern measurements of a 16-elements ultra wideband sparse random test array for the low frequency instrument of the Square Kilometer Array telescope. We discuss the importance of a small array test platform for the development of technologies and techniques towards the final telescope, highlighting the most relevant aspects of its design. We also describe the electromagnetic simulations and modeling work as well as the embedded-element and array pattern measurements using an Unmanned Aerial Vehicle system. The latter are helpful both for the validation of the models and the design as well as for the future instrumental calibration of the telescope thanks to the stable, accurate and strong radio frequency signal transmitted by the UAV. At this stage of the design, these measurements have shown a general agreement between experimental results and numerical data and have revealed the localized effect of un-calibrated cable lengths in the inner side-lobes of the array pattern.

Modern radio astronomical facilities in the Very High-Frequency band (VHF, 30-300 MHz) consist of large antenna arrays with digital beamforming. The calibration of these instruments requires accurate models of their electromagnetic behavior. Numerical models covering the full telescope field-of-view are nowadays effectively computed by means of full-wave solvers. However, their experimental verification is still an open and challenging task. This letter proposes a verification strategy based on near-field scans. An unmanned aerial vehicle carrying a test source is used to excite the array from a limited set of spatial points, located in the radiating near-field region. The collected data are directly used to verify the telescope electromagnetic model without additional postprocessing. This exploits the capability of full-wave solvers to predict near-field patterns from the same geometrical and electrical model used to compute far-field patterns. The application of the proposed technique to the Low Frequency Array (LOFAR) radio telescope verified the predictions with residuals below 0.5 dB.

The Square Kilometre Array (SKA) will be the world’s largest and most sensitive radio telescope ever built, covering the huge fractional bandwidth from 50 MHz to 15.3 GHz. It will bring a revolution in astronomy and astrophysics in the coming decades.¹ When completed, it will consist of two telescopes: the SKA-Mid for the highest frequency end of the bandwidth (above 350 MHz, in the Karoo region of South Africa) and the SKA-Low for the lowest (below 350 MHz, in the Murchison Desert of Western Australia).