Palladium (Pd) has received attention as an ideal hydrogen sensor material due to its properties such as high sensitivity and selectivity to hydrogen gas, fast response, and operability at room temperature. Interestingly, various Pd nanostructures that have been realized by recent developments in nanotechnologies are known to show better performance than bulk Pd. This review highlights the characteristic properties, issues, and their possible solutions of hydrogen sensors based on the low-dimensional Pd nanostructures with more emphasis on Pd thin films and Pd nanowires. The finite size effects, relative strengths and weaknesses of the respective Pd nanostructures are discussed in terms of performance, manufacturability, and practical applicability.
We report thermodynamically controlled multi-segmented nanowires for phonon-glass, electron-crystal materials prepared by on-film formation of nanowires (OFF–ON), which is capable of growing high-quality single-crystalline Bi nanowires by the subsequent sputtering of Te onto the Bi nanowires and by post-annealing. The Bi/Bi14Te6 multi-segmented nanowires exhibit lower thermal conductivities than BixTey compounds, while the electrical conductivities of Bi nanowires and multi-segmented nanowires are similar.
We fabricated Bi nanowire interconnections between two pre-patterned electrodes using a combination of on-film formation of nanowires (OFF-ON) and self-assembly. Bi nanowires were found to grow laterally from a multilayer structure with a Cr (or SiO(2)) overlayer on top of a Bi thin film through thermal annealing to relieve vertically stored compressive stress. A Bi nanobridge with a diameter of 192 nm was formed between two Cr electrodes and was highly ohmic according to I-V measurements. A high transverse magnetoresistance of 123% was also observed at 300 K. Our results indicate that self-assembled lateral nanowire growth can be utilized as an easy means for fabricating a variety of nanowire devices without the use of catalysts or complex patterning processes.
On-film formation of nanowires, termed OFF-ON, is a novel synthetic approach that produces high-quality, single-crystalline nanowires of interest. This versatile method utilizes stress-induced atomic mass flow along grain boundaries in the polycrystalline film to form nanowires. Consequently, controlling the magnitude of the stress induced in the films and the microstructure of the films is important in OFF-ON. In this study, we investigated various experimental growth parameters such as deposition rate, deposition area, and substrate structure which modulate the microstructure and the magnitude of stress in the films, and thus significantly affect the nanowire density. We found that Bi nanowire growth is favored in thermodynamically unstable films that facilitate atomic mass flow during annealing. A large film area and a large thermal expansion coefficient mismatch between the film and the substrate were found to be critical for inducing large compressive stress in a film, which promotes Bi nanowire growth. The OFF-ON method can be routinely used to grow nanowires from a variety of materials by tuning the material-dependent growth parameters.
Crystalline Co nanoparticles were hybridized with single-crystalline Bi nanowires simply by annealing Co-coated Bi nanowires at elevated temperatures. An initially near-amorphous Co film of 2-7 nm in thickness began to disrupt its morphology and to be locally transformed into crystallites in the early stage of annealing. The Co film became discontinuous after prolonged annealing, finally leading to isolated, crystalline Co nanoparticles of 8-27 nm in size. This process spontaneously proceeds to reduce the high surface tension and total energy of Co film. The annealing time required for Co nanoparticle formation decreased as annealing temperature increased, reflecting that this transformation occurs by the diffusional flow of Co atoms. The Co nanoparticle formation process was explained by a hole agglomeration and growth mechanism, which is similar to the model suggested by Brandon and Bradshaw, followed by the nanoparticle refinement.