Remote sensing technology applied to agricultural crops has emerged as an efficient tool to speed up the data acquisition process in decision-making. In this study, we aimed to evaluate the performance of the Normalized Difference Vegetation Index (NDVI) and the Normalized Difference Red Edge (NDRE) in estimating biomass accumulation in common bean crops. The research was conducted at the Federal University of Lavras, where the ANFC 9 cultivar was used in an area of approximately seven hectares, in a second crop, in 2022. A total of 31 georeferenced points spaced at 50 m were chosen to evaluate height, width and green biomass, with collections on days 15, 27, 36, 58, 62 and 76 of the crop cycle. The images used in the study were obtained from the PlanetScope CubeSat satellite, with a spatial resolution of 3 m. The data obtained were subjected to a Pearson correlation (R) test and multiple linear regression analysis. The green biomass variable was significantly correlated with plant height and width. The NDVI performed better than the NDRE, with higher values observed at 62 Days After Sowing (DAS). The model that integrates the parameters of height, width and NDVI was the one that presented the best estimate for green biomass in the common bean crop. The M1 model showed the best performance to estimate green biomass during the initial stage of the crop, at 15, 27 and 36 DAS (R² = 0.93). These results suggest that remote sensing technology can be effectively applied to assess biomass accumulation in common bean crops and provide accurate data for decision-makers.

Estimating cotton fiber quality early in the season, or its field variability, is impractical due to limitations in current methods, and it has not been widely explored. Similarly, few studies have tried estimating the parameters contributing to in-season cotton yield using UAV-based sensors. Thus, this study aims to explore the potential of using UAV-based multispectral images to estimate important in-season parameters, such as intercepted photosynthetically active radiation (IPAR), cotton height, the number of mainstem nodes, leaf area index (LAI), and end-of-the-season yield and cotton fiber quality parameters. Research trials were carried out in 2018 and 2020 in two experimental fields. In both years, a randomized complete block design was used with three cotton cultivars (2018), three plant growth regulators (2020), and three different irrigation levels to promote variability (both years). Cotton growth parameters were collected throughout the season on the same dates as UAV flights. Yield and fiber quality data were collected during harvest. The VI-based models used in this study were mostly sensitive to differences in cotton growth and final yield but less sensitive in detecting variation in cotton fiber quality indicators, such as length, strength, and micronaire, early in the season. The best performing regression model among the three fiber quality indicators was achieved in 2020, using a combination of four VIs, which explained 68% of the micronaire variability at 71 DAP. Results from this study also showed that multispectral-based VIs can be applied as early as the squaring stage at around 44 DAP to estimate most cotton growth indicators and final lint yield. Multiple linear regression validation models for height using NDVI, GNDVI, and RDVI obtained an R² of 0.62, and for LAI using MSR and NDVI an R² of 0.60. For lint yield, the best regression model combined four VIs and explained 66% of the yield variability. The ability to capture the variability in important growth and yield parameters early in the season can provide useful insights on potential crop performance and aid in in-season decisions.