Gul Tosun

Prof. Gul Tosun


Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 December 2003 in Composites Science and Technology
Verified
Journal Article
Closed access
GTGul Tosun
Gul Tosun
MMMehtap Muratoglu
Mehtap Muratoglu

5 September 2013 in Arabian Journal for Science and Engineering
Verified
Journal Article
Closed access
PDF file
GTGul Tosun
Gul Tosun

31 December 2010 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
GTGul Tosun
Gul Tosun

31 May 2012 in Materials and Manufacturing Processes
Verified
Journal Article
Closed access
GTGul Tosun
Gul Tosun
NTNihat Tosun
Nihat Tosun
This article presents optimization of process parameters for the porosity in NiTi alloy produced as implant material by self-propagating high-temperature synthesis (SHS) method. The experiments were conducted under the different process parameters, namely, compaction pressure, preheating temperature, and heating rate. A plan of experiments based on the Taguchi method was designed. The level of importance of the process parameters is determined by using analysis of variance (ANOVA). The optimum process parameter combination was obtained by using the analysis of signal-to-noise (S/N) ratio. Through statistical analysis of response variables and S/N ratios, the determined significant factors were the heating rate and pressure. By using regression analysis method, the variation of the porosity in the implant with production parameters is mathematically modeled.

18 September 2019 in Surface Engineering
Verified
Journal Article
Closed access
GTGul Tosun
Gul Tosun
LOLatif Ozler
Latif Ozler
MOMehmet Erbil Ozcan
Mehmet Erbil Ozcan
In this paper, a substrate material (AA5754) was coated using a consumable rod/coating shaft (AA7075) as both a single layer and gradient layers by friction stir process. The order of the gradient coating process can be listed as; mixing the Al + TiC powders, pressing inside the consumable rod, sintering at certain temperatures and coating the substrate material surface with three overlapping layers at different reinforcement ratios. Microhardness and wear tests were performed to investigate the mechanical properties of the coatings. The microstructures of the coated materials have been examined by using optical microscope and SEM. The EDX and XRD analyses were also applied to the new-coated materials. The shaft rotational speed had a significant effect on the microstructure in the friction coating which was performed at single layer and in a powder-free fashion. The gradient ratio in gradient coatings had a considerable effect on the hardness and wear resistance.

13 February 2014 in Arabian Journal for Science and Engineering
Verified
Journal Article
Closed access
PDF file
GTGul Tosun
Gul Tosun