Diffusion dialysis (DD) employing anion exchange membranes (AEMs) presents an attractive opportunity for acid recovery from acidic wastewater. However, challenges exist to make highly acid permeable AEMs due to their low acid dialysis coefficient (). Here, a series of porous and highly acid permeable AEMs fabricated based on chloromethyl polyethersulfone (CMPES) porous membrane substrate with crosslinking and quaternization treatments is reported. Such porous AEMs show high because of the large free volume as well as the significantly reduced ion transport resistance relative to the dense AEMs. Compared with the commercial dense DF-120 AEM, our optimal porous AEM show simultaneous 466.7% higher and 75.7% higher acid/salt separation factor () when applied to acid recovery at the same condition. Further, considering the simple and efficient fabrication process as well as the low cost, our membranes show great prospects for practical acid recovery from industrial acidic wastewater.
19 November 2019 in Adsorption Science & Technology
The adsorption of Rhodamine B onto CT269DR resin has been studied through static and dynamic experiments. The effects of shaking speed, resin dosage, and pH on adsorption were investigated by static experiments. The external mass transfer rate remains substantially unchanged when the shaking speed exceeds 160 r min−1. The optimal pH range is 5–8, and an increase of resin dosage can directly improve the percentage of removal of Rhodamine B. The equilibrium isotherm data of Rhodamine B on CT269DR resin fit the Langmuir adsorption isotherm well. The thermodynamics parameters, Δ H = 69.93 kJ mol−1, Δ S = 326.73 J mol−1 K−1, and Δ G < 0, demonstrate that the adsorption of Rhodamine B onto CT269DR resin is spontaneous and endothermic. The pseudo first-order kinetic model can be successfully used to represent the adsorption process and the activation energy is 25.7 kJ mol−1. The dynamic experiments show that the breakthrough point is advanced when the flow rate increases and the bed adsorption capacity increases with increasing temperature. Furthermore, the desorption using the solution of 2% NaOH is suitable for desorption and reusing process, and scanning electron microscope (SEM) and fourier transform infrared spectroscopy (FT-IR) analysis reveals that used resin has good wear resistance and chemical stability. The results confirm that CT269DR resin can be employed as an efficient adsorbent for the removal of Rhodamine B from wastewater.