Landslide phenomena involve the northern coast of Malta, affecting in particular the urban area of Xemxija. Limestones overlying a clayey formation represent the shallower lithotypes that characterize the surficial geology of this area, where lateral spreading phenomena and rockfalls take place. Ambient noise records, processed through spectral ratio techniques, were analysed in order to characterize the dynamic behavior of the rock masses affected by the presence of fractures linked to the landslide body existing in the area. Experimental spectral ratios were also calculated after rotating the horizontal components of the seismic signal, and a direct estimate of the polarization angle was also performed in order to investigate the existence of directional effects in the ground motion. The results of the morphologic survey confirmed the existence of large cliff-parallel fractures that cause cliff-edge and unstable boulder collapses. Such phenomena appear connected to the presence, inside the clay formation, of a sliding surface that was identified through the interpretation of the noise measurement data. The boundaries of the landslide area appear quite well defined by the pronounced polarization effects, trending in the northeastern direction, observed in the fractured zone and in the landslide body in particular.

Bidirectional phase-stabilized optical fiber links allow state-of-the-art optical clocks to be compared on a continental scale. However, intercontinental comparisons are still based on satellite techniques, preventing optical clocks from being compared without degradation. We performed the first optical frequency transfer experiment over submarine links, measuring levels of environmentally induced noise substantially lower than for on-land links. From these measurements, we predict the transfer stability that can be achieved over transoceanic links. We also performed the first optical frequency transfer over fibers installed in power cables, observing optical perturbations caused by the high-voltage field. Finally, we show that the low background noise of fibers on the seafloor allows applications in geophysical sensing.

The islands composing the Maltese archipelago (Central Mediterranean) are characterized by a four-layer sequence of limestones and clays. A common feature found in the western half of the archipelago is Upper Coralline Limestone (UCL) plateaus and hillcaps covering a soft Blue Clay (BC) layer which can be up to 75 m thick. The BC layer introduces a velocity inversion in the stratigraphy, implying that the V_S30 (traveltime average sear wave velocity (V_S) in the upper 30 m) parameter is not always suitable for seismic microzonation purposes. Such a layer may produce amplification effects, however might not be included in the V_S30 calculations. In this investigation, V_S profiles at seven sites characterized by such a lithological sequence are obtained by a joint inversion of the single-station Horizontal-to-Vertical Spectral Ratios (H/V or HVSR) and effective dispersion curves from array measurements analysed using the Extended Spatial Auto-Correlation technique. The lithological sequence gives rise to a ubiquitous H/V peak between 1 and 2 Hz. All the effective dispersion curves obtained exhibit a ‘normal’ dispersive trend at low frequencies, followed by an inverse dispersive trend at higher frequencies. This shape is tentatively explained in terms of the presence of higher mode Rayleigh waves, which are commonly present in such scenarios. Comparisons made with the results obtained at the only site in Malta where the BC is missing below the UCL suggest that the characteristics observed at the other seven sites are due to the presence of the soft layer. The final profiles reveal a variation in the V_S of the clay layer with respect to the depth of burial and some regional variations in the UCL layer. This study presents a step towards a holistic seismic risk assessment that includes the implications on the site effects induced by the buried clay layer. Such assessments have not yet been done for Malta.

Anchor Bay and surrounding regions are located on the northwest coast of the island of Malta, Central Mediterranean. The area is characterized by a coastal cliff environment having an outcropping layer of hard coralline limestone (UCL) resting on a thick (up to 50 m) layer of clays and marls (Blue Clay, BC). This configuration gives rise to coastal instability effects, in particular lateral spreading phenomena and rock falls. Previous and ongoing studies have identified both lateral spreading rates and vertical motions of several millimetres per year. The area is an interesting natural laboratory as coastal detachment processes in a number of different stages can be identified and are easily accessible. We investigate the site dynamic characteristics of this study area by recording ambient noise time-series at more than 30 points, over an area of 0.07 km², using a portable three-component seismograph. The time-series are processed to give both horizontal-to-vertical spectral ratio graphs (H/V) as well as frequency-dependent polarisation analysis. The H/V graphs illustrate and quantify aspects of site resonance effects due both to underlying geology as well as to mechanical resonance of partly or wholly detached blocks. The polarization diagrams indicate the degree of linearity and predominant directions of vibrational effects. H/V curves closer to the cliff edge show complex responses at higher frequencies, characteristic of the dynamic behaviour of individual detached blocks. Particle motion associated with the higher frequencies shows strongly directional polarization and a high degree of linearity at well-defined frequencies, indicative of normal-mode vibration. The stable plateau areas, on the other hand, show simple, single-peak H/V curves representative of the underlying stratification and no predominant polarization direction. These results, which will be compared with those from other experiments in the area, have important implications for the understanding of ongoing processes in geologically active and unstable coastal environments.

The cliff slope of the Selmun Promontory, located in the Northern part of the island of Malta (Central Mediterranean Sea) close to the coastline, is involved in a landslide process as exhibited by the large block-size talus at its bottom. The landslide process is related to the geological succession outcropping in the Selmun area, characterised by the over-position of a grained limestone on a plastic clay, that induces a lateral spreading phenomenon associated with detachment and collapse of different-size rock blocks. The landslide process shapes a typical landscape with a stable plateau of stiff limestone bordered by an unstable cliff slope. The ruins of Għajn Ħadid Tower, the first of the thirteen watchtowers built in 1658 by the Grand Master Martin de Redin, stand out on the Selmun Promontory. The conservation of this important heritage site, already damaged by an earthquake which struck the Maltese Archipelago on October 12^th 1856, is currently threatened by a progressive retreat of the landslide process towards the inland plateau area. During 2015 and 2016, field surveys were carried out to derive an engineering geological model of the Selmun Promontory. After a high-resolution geomechanical survey, the spatial distribution of the joints affecting the limestone was obtained. At the same time, 116 single-station noise measurements were carried out to cover the inland and edge plateau zones as well as the clayey slope area. The obtained 1-hour time histories were analysed through the horizontal to vertical spectral ratio (HVSR) technique, as well as polarity and ellipticity analysis of particle motion to define the local seismic response in zones having different stability conditions, i.e. related to the presence of unstable rock blocks characterised by different vibrational modes. The results obtained confirm the suitability of passive seismic geophysical techniques for zoning landslide hazard in case of rock slopes and demonstrate the relevance of anisotropies in conditioning the polarization of vibrational modes for dislodged rock masses.