The use of lead as a primary coolant is one of the most attractive options for next-generation lead-cooled fast reactor systems (LFR). Despite many favourable features, liquid Pb is a harsh environment that induces many problems on metallic components. Therefore, candidate materials for LFR must be qualified, and the solutions to improve their properties must be found. This paper’s objective is to present the results obtained from the tensile tests of AISI 316L steel in liquid lead at 400 °C, 450 °C, and 500 °C, and the short-term corrosion tests performed on coated and uncoated AISI 316L steel at 550 °C. The coating was made of Al₂O₃ with a CrNiAlY interlayer using the electron beam-physical vapor deposition (EB-PVD) technique. Both the mechanical and corrosion tests were performed in stagnant lead saturated with oxygen. After testing, the specimens were characterised by several analyses, including scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), optical microscopy (OM), scratching test, and Vickers micro-hardness test. The tensile test results highlight the ductile behaviour of the material, and in the case of the corrosion tests, the coatings prove to be effective in protecting the substrate from the harsh environment.

The 316L stainless steel, uncoated and coated with two types of EB-PVD thin-film deposits, was tested in liquid lead both under oxygen-saturated conditions (~10⁻³ wt.%) for exposure times of 1000 and 2000 h and under low-oxygen conditions (~10⁸ wt.%) for 1000 h. The first coating consisted of a ~1 µm NiCrAlY thin film. At the same time, the second was a NiCrAlY/Al₂O₃ multilayer with a total thickness of ~3 µm, on top of which an additional 100–200 nm metallic Cr layer was deposited. Uncoated specimens tested under oxygen-saturated conditions developed a duplex oxide layer on their surface. SEM-EDS analyses revealed that the inner layer was denser and contained Fe, Cr, and O, whereas the outer layer was more porous and composed mainly of Fe and O. Microscopic examinations indicated that the multilayer-coated specimens exposed to low-oxygen conditions exhibited no signs of material degradation. In contrast, both the uncoated samples and those coated only with a single NiCrAlY layer showed generalised corrosion over the entire surface after exposure to liquid lead at low oxygen concentrations. The austenitic microstructure was degraded to a depth of 100–200 µm. Vickers microhardness indentations performed on the structurally altered regions revealed two distinct corrosion zones with markedly different hardness values.