Jinlong Chen

Dr. Jinlong Chen


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2023 in Energies
Verified
Journal Article
Open access
PDF file
JDJin Dong
Jin Dong
ZHZhilong Huang
Zhilong Huang
JCJinlong Chen
Jinlong Chen
TLTianjun Li
Tianjun Li
JZJing Zhao
Jing Zhao
TQTong Qu
Tong Qu
Various experiments, including routine petrophysical measurements, thin section and scanning electronic microscope (SEM), high-pressure mercury intrusion (HPMI), and nuclear magnetic resonance (NMR), were performed to characterize the microscopic pore structure of tight sandstone in the Huagang Formation (E3h), Xihu Sag, East China Sea Basin, China. Specifically, NMR was used to investigate the dynamic variation of fractal dimensions during centrifugation, and the comparison of HPMI and NMR were used to clarify the difference of fractal dimensions. The results showed that there were four types of pores observed in thin section and SEM images: primary intergranular pores, intergranular dissolution pores, intragranular dissolution pores, and micropores within clay aggregates. The geometric shape and pore size of different pore types showed huge differences, indicating the formation of complex and diverse pore structures in the E3h formation. The flow capability of the reservoir was dominated by large pores, while the storage capacity was determined by small pores. The dynamic variation of fractal dimensions calculated by NMR data showed the water residing in the pore structure with low fractal dimensions was removed preferentially, and the pore structure of the resided water was always more complicated than the pore structure of removed water, which indicated the flow capability of the reservoir was affected by the complexity of the pore structure. Based on the comparison of the fractal dimension data from HPMI and NMR, it was found that the variation trends of the fractal dimensions were consistent, as the radius of the pore throat increased, the fractal dimensions increased, and the pore structure became more complicated. Both fractal dimensions of macropores (Dmac) and movable-fluid pores (Dmov) can reflect the flow capability of reservoir effectively, but the correlations between fractal dimensions from HMPI and NMR were poor, which could be due to the different working mechanism in these methods.

21 June 2023 in Processes
Verified
Journal Article
Open access
PDF file
JCJinlong Chen
Jinlong Chen
ZHZhilong Huang
Zhilong Huang
GYGenshun Yao
Genshun Yao
WZWeiwei Zhang
Weiwei Zhang
YPYongshuai Pan
Yongshuai Pan
TQTong Qu
Tong Qu
Using different experimental methods, the pore radius ranges vary greatly, and most scholars use a single experiment to study pore structure, which is rarely consistent with reality. Moreover, the numerical models used in different experiments vary and cannot be directly compared. This article uniformly revised all experimental data into a cylinder model. Quantitative analysis of the full-scale pore distribution is established by mercury withdrawal–CT data, and semi-quantitative distribution is obtained by mercury–NMR–cast thin section imaging. In this paper, we introduce the tortuosity index (τ) to convert the CT ball-and-stick model into a cylinder model, and the pore shape factor (η) of the cast is used to convert the plane model into the cylinder model; the mercury withdrawal data is applied to void the influence of narrow throat cavities, and the NMR pore radius distribution is obtained using the mercury-T2 calibration method. Studies have shown that the thickness of bound water is 0.35~0.4 μm, so the pores with different radius ranges were controlled by different mechanisms in the NMR tests, with pores < 0.35~0.4 μm completely controlled by surface relaxation, including strong bound water and weak bound water; pores in the 0.4~4 μm reange were controlled by surface relaxation; and pores > 10 μm were completely controlled by free relaxation. The surface relaxivity rate of fine sandstone was 18~20 μm/s. The tortuosity index τ was generally 1~7; the larger the value, the more irregular the pores. The pore shape factor η was generally 0.2~0.5; the smaller the value, the more irregular the pores. Mercury withdrawal–CT scan data can quantitatively determine the pore radius distribution curve. The coefficient of the logarithm is positive considering porosity, and the constant is negative considering porosity. Permeability controls the maximum pore radius, with a max pore radius > 100 μm and a permeability > 1 mD. Mercury withdrawal–NMR–cast thin section imaging data can semi-quantitatively establish a pore radius distribution histogram. The histogram represents quasi-normal, stepped, and unimodal data. When 60 μm is the inflection point, if a large proportion of pores measure > 60 μm, good reservoir quality is indicated. If a large proportion of pores measures < 60 μm, the permeability is generally <0.5 mD.

21 March 2023 in Preprints.org
Verified
Preprint
Open access
PDF file
JCJinlong Chen
Jinlong Chen
ZHZhilong Huang
Zhilong Huang
GYGenshun Yao
Genshun Yao
HFHongche Fan
Hongche Fan
Reservoir in the Central Structural Zone of the Xihu Sag is the Huagang Formation, dominated by natural gas reservoirs, and the reservoir in the Western Slope Zone is the Pinghu Formation, dominated by light oil and wet gas. In this paper, the Gas Drive Water Displacement- Magnetic Resonance Imaging (GWD-MRI) experiments are used to simulate the charging characteristics of the sandstone migration layer. The centrifugal- Magnetic Resonance (Cen-NMR) experiments simulate the short-term fast trap charging process, and the Semi-Permeable Baffle (SPB) charging experiment simulates the slow trap accumulation process. Studies have shown that there is a start-up pressure for the migration layer charging, and the start-up pressure of the core with a permeability of 0.3mD is about 0.6MPa. Experimental simulations have confirmed that there is a front zone with changed water saturation, with a width of about 1-1.5cm. The migration layer charging mainly has two actions, drive effect and carry effect. The drive effect reduces the water saturation to 70%-80%, and the carry effect can still reduce the water saturation by 5%-10%. The water saturation of rapid charging is mainly affected by the petro-physical. The porosity is high, the water saturation is low. The water saturation decreased significantly with the increase of centrifugal force when the centrifugal force is smaller. If the centrifugal force is greater than 0.8 MPa, the water saturation decreases slowly. The water saturation of the trap slowly charging is basically maintained at 40%-50%, which matches the water saturation of the airtight coring from 40%-55%, the petro-physical do not affect the final water saturation.

7 November 2023 in Processes
Verified
Journal Article
Open access
PDF file
JDJin Dong
Jin Dong
ZHZhilong Huang
Zhilong Huang
JCJinlong Chen
Jinlong Chen
TLTianjun Li
Tianjun Li
TQTong Qu
Tong Qu
YYYizhuo Yang
Yizhuo Yang
The Xihu Sag in the East China Sea Basin is located at the edge of the eastern Chinese continent and has great exploration potential. In recent years, the development of low-permeability and tight sandstone gas has become an important area of exploration and development in the Huagang Formation (E3h) of the Xihu Sag. The tight sandstone reservoir in the Xihu Sag is characterized by serious heterogeneity, high water saturation, low resistivity, and a complex gas–water relationship. Because of these characteristics of tight sandstone reservoirs, it is difficult to perform an evaluation of them. In this work, a bimodal Gaussian density function was constructed using the data of high-pressure mercury intrusion (HPMI) and nuclear magnetic resonance (NMR); this approach was used to analyze the pore structure parameters. The reservoirs were divided into four types using the fitting parameter η, and the rock electric parameters that correspond to different pore structures were quite different. When combined with the log response equation of η with acoustic interval transit time (AC), density (DEN), and natural gamma (GR) logging curves, an evaluation method of gas-bearing properties that was based on the characteristics of the pore structure was established. Compared with the water saturation test of the sealing core, it was found that the water saturation calculated by the classification of the pore structure was more accurate than that obtained by the conventional method, and the error was less than 8.35%, which proves that this method is feasible and effective. The findings of this study can help provide a better understanding of the distribution characteristics of gas and water in tight sandstone and provide help for tight gas exploration and development.

24 April 2023 in Processes
Verified
Journal Article
Open access
PDF file
JCJinlong Chen
Jinlong Chen
ZHZhilong Huang
Zhilong Huang
GYGenshun Yao
Genshun Yao
HFHongche Fan
Hongche Fan
The Xihu sag has two main oil−gas fields: Huagang Gas Field and Pinghu Oil Field. The Huagang formation is the reservoir of the Huagang Gas Field in the Central Tectonic Zone, while the Pinghu formation is the reservoir of the Pinghu Oil Field in the Western Slope Zone. In this paper, which mainly focusses on the Huagang formation, we conducted gas-driven water displacement–magnetic resonance imaging (GWD-MRI) experiments to simulate the charging characteristics of the sandstone migration layer, centrifugal magnetic resonance (Cen-NMR) experiments to simulate the short-term rapid trap charging process, and semi-permeable baffle (SPB) charging experiments to simulate the slow trap accumulation process. The results indicate that a start-up pressure exists for migration layer charging, where the start-up pressure for a core with a permeability of 0.3 mD is about 0.6 MPa. Our experimental simulations confirm that a planar front of changing water saturation exists, which has a width of about 1–1.5 cm. Migration layer charging is mainly influenced by two actions: the drive effect and the carrying effect. The drive effect can reduce the water saturation to 70–80%, while the carrying effect can further reduce the water saturation by 5–10%. The water saturation in the rapid charging scenario is mainly affected by the petrophysical characteristics of the rock: if the porosity is high, the water saturation is low. The water saturation decreases significantly with the increase in centrifugal force when the centrifugal force is small; however, when the centrifugal force is greater than 0.8 MPa, the water saturation decreases slowly. In the slowly charging trap experiment, the water saturation was basically stable at 40–50%, which matched the measured water saturation of the airtight cores well (ranging from 40–55%), and the petrophysical characteristics of the rock did not have a significant effect on the final water saturation.