The rapid development of microelectronic devices has stimulated an increasing demand for micro-energy storage devices, typically, micro-supercapacitors (MSCs). Despite recent advances, the fabrication of MSCs using a facile, scalable and inexpensive method still remains challenging. In this work, we use a facile screen printing technique to fabricate flexible all-solid-state MSCs using N-doped reduced graphene oxide (rGO) as the electrode material. The effective area of MSCs and the thickness of the active material are only 0.396 cm2 and 10 μm, respectively. The MSCs can deliver a high specific areal capacitance of 3.4 mF cm−2, which is among the high values of graphene-based materials for all-solid-state MSCs reported so far. Easy fabrication and good performance make MSCs promising on-chip energy storage devices.
Nanostructuring and second phase incorporation are considered to be promising ways of enhancing the thermoelectric performance of bulk materials. Here, a design principle is proposed which combines these two methods for improving the thermoelectric performance of p-type CoSb3 by fabricating a CoSb3/graphene (CoSb3/G) nanocomposite, where a second phase, graphene, is introduced in the nanostructured CoSb3 matrix via an in situ one-pot solvothermal route. In addition, CoSb3/G bulk materials were prepared by hot pressing the solvothermally synthesized CoSb3/G powder. It was found that addition of a small amount of graphene can drastically enhance the electrical conductivity due to the increase in both carrier concentration and mobility. In addition, the well dispersed graphene in the nanostructured CoSb3 matrix also contributes to the low lattice thermal conductivity. A dimensionless figure of merit ZT = 0.61 at 800 K has been obtained for the CoSb3/G nanocomposite, which is about a 130% improvement over that of graphene-free CoSb3 (∼0.26).
A CoFe2O4-nanocrystal/graphene-nanosheet (CFO/GS) nanohybrid has been synthesized by a facile in situ solvothermal route and has been investigated as a promising high-performance anode material for Li-ion batteries. The crystal size of CoFe2O4 can be controlled to 10–20 nm by pre-treating the precursors before the solvothermal reactions. The method for synthesizing the CFO/GS hybrid can be extended to synthesize MFe2O4/graphene (MFe2O4/G, M = Mn and Ni) hybrids. The CFO/GS hybrid exhibits superior cycling stability and rate capability compared to bare CoFe2O4. The improved electrochemical performance can be attributed to a combination of the conducting, confining and dispersing effects of graphene.