Facile, convenient and low-cost processes, including a chemical hydrothermal method and impregnation technique, were demonstrated to fabricate a self-powered ZnO nanorod array/CuSCN/reduced graphene oxide (rGO) ultraviolet photodetector. ZnO nanorods (NRs) were fully filled and encased by the CuSCN layer, in which CuSCN acts as the primary hole-transport layer and an electron reflection layer, blocking the electron transfer towards the Au electrode and reducing the electron–hole pair recombination. After annealing, this encapsulated structure further reduces the surface state defects of ZnO NRs, which can isolate the electron exchange with oxygen in the air, dramatically reducing the rise and fall time; it also forms a p–n junction, providing a built-in electric field to improve the photoresponse without applying external power. The rGO layer was coated on the surface of CuSCN as the secondary hole-transport layer and then annealed, which could effectively block Au from entering CuSCN and contacting ZnO along cracks and holes during vapor deposition, avoiding the formation of leakage channels. Furthermore, due to the ultra-high carrier mobility and the increase in work function after Au doping, the functionalized graphene could reduce the valence band shift, which is beneficial to enhance hole transport. Meanwhile, rGO obstructs the undesired barrier formed by electrical potential-induced reaction of Au with thiocyanate anions. Finally, the ZnO NR/CuSCN/rGO ultraviolet photodetector exhibits a significant enhancement in device performance (responsivity: 18.65 mA W−1 at 375 nm under 65 mW cm−2 illumination, rectification ratio: 5690 at ±1 V), which is better that of than ZnO NR/CuSCN structure (10.88 mA W−1, 10.22 at ±1 V) and maintains the 100 ms response time.
1 November 2021 in Materials Science in Semiconductor Processing
In this paper, we demonstrate a new heterojunction ultraviolet (UV) photodetector in a superstrate configuration, i.e. glass/FTO/ZnO NRs/rGO/Au, constructed via the dip-coated method to form reduced graphene oxide (rGO) layer on the surface of ZnO nanorod arrays (NRs). The rGO compensates for surface oxygen vacancies by the oxygen-containing groups and improves the crystal properties of ZnO NRs after annealing. Furthermore, the carrier mobility and work function are effectively increased after Au doping. Under UV irradiation, the electron–hole pairs generated by ZnO NRs are separated with bias voltage, and the electrons and holes are collected via fluorine-doped tin dioxide (FTO) and rGO/Au, respectively. The rGO acts as a hole transport layer, which reduces the recombination of carriers and increases the current density, giving rise to a higher responsivity (67.48 A W −1 at −1.5 V bias) than pure ZnO NRs photodetectors.
26 July 2010 in International Journal of Photoenergy
Deposition of thin films on soda-lime glass substrates by coevaporation of Sb and Te is described in this paper. thin films were characterized by x-ray diffraction (XRD), x-ray fluorescence (XRF), atomic force microscopy (AFM), x-ray photoelectron spectroscopy (XPS), electrical conductivity measurements, and Hall measurements. The abnormal electrical transport behavior occurred from in situ electrical conductivity measurements. The results indicate that as-grown thin films are amorphous and undergo an amorphous-crystalline transition after annealing, and the posttreatment can effectively promote the formation of Sb-Te bond and prevent oxidation of thin film surface.