Indrakshi Dey

Dr. Indrakshi Dey

Walton Institute, South East Technological University, Waterford, Ireland
orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2020 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
IDIndrakshi Dey
Indrakshi Dey
Domenico CiuonzoDomenico Ciuonzo
Domenico Ciuonzo
PRPierluigi Salvo Rossi
Pierluigi Salvo Rossi
In this paper, in order to tackle major challenges of spectrum exploration & allocation in Cognitive Radio (CR) networks, we apply the general framework of Decision Fusion (DF) to wideband collaborative spectrum sensing based on Orthogonal Frequency Division Multiplexing (OFDM) reporting. At the transmitter side, we employ OFDM without Cyclic Prefix (CP) in order to improve overall bandwidth efficiency of the reporting phase in networks with high user density. On the other hand, at the receiver side (of the reporting channel) we device the Time-Reversal Widely Linear (TR-WL), Time- Reversal Maximal Ratio Combining (TR-MRC) and modified TR-MRC (TR-mMRC) rules for DF. The DF Center (DFC) is assumed to be equipped with a large antenna array, serving a number of unauthorized users competing for the spectrum, thereby resulting in a “virtual” massive Multiple-Input Multiple- Output (MIMO) channel. The effectiveness of the proposed TRbased rules in combating (a) inter-symbol and (b) inter-carrier interference over conventional (non-TR) counterparts is then examined, as a function of the Signal-to-Interference-plus-Noise Ratio (SINR). Closed-form performance, in terms of system falsealarm and detection probabilities, is derived for the formulated fusion rules. Finally, the impact of large-scale channel effects on the proposed fusion rules is also investigated, via Monte-Carlo simulations.

13 January 2014 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
IDIndrakshi Dey
Indrakshi Dey
GMGeoffrey G. Messier
Geoffrey G. Messier
SMSebastian Magierowski
Sebastian Magierowski
This paper presents measurements and a propagation model for an indoor wireless LAN (WLAN) scenario that represents an open concept office or laboratory layout with few large obstacles to reflect and refract the transmitted signal. Most mobile WLAN users generally restrict their movements to a small area due to the inability of most WLANs to accommodate hand-offs. As a result, users travel through at most one or two scattering clusters and experience only one or two discrete shadowing values. Hence, this paper will use propagation measurements collected over bandwidths of 10 MHz, to develop a statistical model for shadowing suitable for such an indoor WLAN scenario. Moreover, in indoor environments shadowing varies quickly enough to require some channel estimation algorithms to account for both small scale and large scale statistics. Therefore, this paper will present a distribution that jointly models variations due to both Rician fading and the new shadowing model. An analytical expression for the probability density function (PDF) of the joint distribution will be derived and fit to the experimental propagation data.

20 May 2019 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Open access
IDIndrakshi Dey
Indrakshi Dey
PRPierluigi Salvo Rossi
Pierluigi Salvo Rossi
MBMajid Butt
Majid Butt
NMNicola Marchetti
Nicola Marchetti
In this paper, we investigate the practical implications of employing virtual multiple-input-multiple output (MIMO) systems for prototyping future-generation wireless sensor networks, especially in the light of recently proposed distributed detection based decision fusion rules. In order to do that, an indoor-to-outdoor measurement campaign has been conducted recently for investigating the propagation characteristics of an 8 × 8 virtual multiple-input-multiple-output (MIMO) system. The campaign is conducted with transmit antennas representing the sensors deployed in different indoor environments and receive antennas mounted on an outside tower representing the decision fusion center. Channel measurements are reported when a 20 MHz wide signal is transmitted at 2.53 GHz. Measurements are collected for different spatial combinations of the transmit antennas. After analyzing the collected data, performance of different decision fusion rules are compared and tested over the measured channel. The results show that the fusion rules perform differently over different sets of measured channels. The results obtained here are important for maximizing performance and enabling air-interface design of next-generation wireless sensor networks.

29 May 2020 in IEEE Transactions on Communications
Verified
Journal Article
Closed access
IDIndrakshi Dey
Indrakshi Dey
PRPierluigi Salvo Rossi
Pierluigi Salvo Rossi
MBM. Majid Butt
M. Majid Butt
NMNicola Marchetti
Nicola Marchetti
In this paper, we investigate the practical implication of employing virtual massive multiple-input-multiple output (MIMO) based distributed decision fusion (DF) for collaborative wideband spectrum sensing (WSS) in a cognitive radio (CR)-like network. Towards that end, an indoor-only measurement campaign has been conducted to capture the propagation statistics of a 4 × 64 massive MIMO system with one authorized primary user (PU) and 4 unauthorized secondary users (SUs) transmitting simultaneously over a 20 MHz band divided into 1200 subcarriers. The frequency subcarriers belong to an Orthogonal-frequencydivision- multiplexing (OFDM)-like set-up without the addition of cyclic prefix (CP) to the transmit symbols. Measurements are accumulated for different relative positions of the SUs which are analyzed to extract fading, shadowing, noise and interference power statistics. Log-likelihood ratio (LLR) based fusion rule and three different sets of sub-optimum fusion rules along with their time-reversed versions are formulated for combining decisions on the availability of each subcarrier transmitted by the SUs. The extracted channel characteristics are incorporated in both analytical and simulated performance analysis of the devised fusion rules for comparison and testing the validity of distributed DF in realistic collaborative WSS scenario.

27 February 2020 in IEEE Internet of Things Journal
Verified
Journal Article
Closed access
MBMajid Butt
Majid Butt
IDIndrakshi Dey
Indrakshi Dey
MDMerim Dzaferagic
Merim Dzaferagic
MMMaria Murphy
Maria Murphy
NKNicholas Kaminski
Nicholas Kaminski
NMNicola Marchetti
Nicola Marchetti
An increasing number of emerging applications, e.g., Internet of Things (IoT), vehicular communications, augmented reality, and the growing complexity due to the interoperability requirements of these systems, lead to the need to change the tools used for the modeling and analysis of those networks. Agent-Based Modeling (ABM) as a bottom-up modeling approach considers a network of autonomous agents interacting with each other, and therefore represents an ideal framework to comprehend the interactions of heterogeneous nodes in a complex environment. Here, we investigate the suitability of ABM to model the communication aspects of a road traffic management system as an example of an IoT network. We model, analyze and compare various Medium Access Control (MAC) layer protocols for two different scenarios, namely uncoordinated and coordinated. Besides, we model the scheduling mechanisms for the coordinated scenario as a high level MAC protocol by using three different approaches: Centralized Decision Maker, Desync and decentralized learning MAC (L-MAC). The results clearly show the importance of coordination between multiple decision makers in order to improve the information reporting error and spectrum utilization of the system.

25 October 2021
Verified
Conference Paper
Open access
SSShama Siddiqui
Shama Siddiqui
AKAnwar Ahmed Khan
Anwar Ahmed Khan
KDKapal Dev
Kapal Dev
IDIndrakshi Dey
Indrakshi Dey
Wearable and ambient sensors have been increasingly used for unique remote health monitoring applications. In this work, we propose an Internet of Medical Things (IoMT) architecture based on automated sensing of physiological and ambient parameters, to detect the risk of obesity in individuals. Timely assessment of obesity risk could improve the quality of life for patients in future as it would help to reduce the probability of chronic diseases such as diabetes. The architecture uses Body Mass Index (BMI) of patient as an input parameter which is a key measure to indicate obesity. Furthermore, we also propose to integrate the proposed IoMT architecture with the emerging scheme of Federated Learning (FL). FL has been used to recommend the appropriate fitness routine for the users. MATLAB simulations for the proposed FL algorithm has been performed and the variations in the loss functions have been observed.