Abdul Mannan Rauf

Mr. Abdul Mannan Rauf


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 May 2023 in Energies
Verified
Journal Article
Open access
PDF file
ARAbdul Mannan Rauf
Abdul Mannan Rauf
MAMohamed Abdel-Monem
Mohamed Abdel-Monem
Thomas GeuryThomas Geury
Thomas Geury
Omar HegazyOmar Hegazy
Omar Hegazy
Recently, multilevel converters (MLCs) have gained significant attention for stationary applications, including static compensators, industrial drives, and utility-grid interfaces for renewable energy sources. Compared to two-level voltage-source inverters (VSI) MLCs feature high-quality AC voltage with reduced harmonic content despite the lower switching frequency of the semiconductor devices. On the DC side, MLCs can integrate multiple isolated/non-isolated battery modules instead of a single battery pack. This helps to keep the system in service in case of a malfunction of one or more battery modules, as well as active balancing among the modules, a feature not possible with two-level VSI. In general, MLCs can be classified into two types: (i) two-port MLCs, which provide a single interface to connect with the battery pack, and (ii) multiport MLCs, which provide multiple interfaces to allow connection at the module or cell level. The classical topologies of both MLC types (e.g., neutral point clamped, flying capacitor, cascaded bridge) face limitations due to the high switch count. Consequently, many hybrid and reduced-switch topologies are reported in the literature. This paper presents a critical overview of both classical and recently reported MLC topologies and offers a better insight of MLC operation for grid-connected and standalone applications. In addition, the analysis thoroughly assesses various high-level control and modulation strategies while considering active balancing among the battery modules. Other salient features such as balancing speed during offtake/grid-injection mode and fault-ride-through capability are also incorporated. In conclusion, the key findings are summarized for a better understanding of the present and future integration of battery systems in stationary applications.

21 February 2026 in Energies
Verified
Journal Article
Open access
PDF file
ARAbdul Mannan Rauf
Abdul Mannan Rauf
Thomas GeuryThomas Geury
Thomas Geury
Omar HegazyOmar Hegazy
Omar Hegazy
AC battery systems (ACBSs) based on multilevel converters (MLCs) have gained considerable attention in recent times for the provision of grid services due to high-power (HP) and high-energy (HE) capabilities. In a hybrid ACBS, multiple low-voltage ports provide DC interfaces for battery modules from the same or different chemistries, enabling flexible operation across a wide range of grid services. However, the design complexity increases substantially, due to (i) higher electrothermal coupling between heterogeneous battery modules and power electronic (PE) switches, (ii) grid compliance constraints and (iii) power quality requirements, which often leads to conservative oversizing and, consequently, increased total cost of ownership (TCO). To address these challenges, this paper proposes a co-design optimization framework for the sizing and selection of battery modules, PE components, and MLC architecture. A multi-fidelity modeling approach is presented to co-simulate the battery modules and MLC. The model captures electrochemical behavior, degradation dynamics, and power losses to enable accurate estimation of system-level energy efficiency. The framework then leverages a multi-objective nondominated sorting genetic algorithm (NSGA-II) to perform optimal cell-to-module sizing across different chemistries and MLC levels, while incorporating the inter-module balancing and AC power quality constraints. Comparative simulation studies show that the proposed co-design framework achieves life-cycle TCO reduction of 3.5%, 4.5% and 20% relative to non-hybrid (single chemistry) configurations based on LFP, NMC and LTO chemistries, respectively. The test results validate the effectiveness of the proposed co-design methodology for the optimal design of grid-tied AC battery systems.