The access to Android-based Global Navigation Satellite Systems (GNSS) raw measurements has become a strong motivation to investigate the feasibility of smartphone-based positioning. Since the beginning of this research, the smartphone GNSS antenna has been recognized as one of the main limitations. Besides multipath (MP), the radiation pattern of the antenna is the main site-dependent error source of GNSS observations. An absolute antenna calibration has been performed for the dual-frequency Huawei Mate20X. Antenna phase center offset (PCO) and variations (PCV) have been estimated to correct for antenna impact on the L1 and L5 phase observations. Accordingly, we show the relevance of considering the individual PCO and PCV for the two frequencies. The PCV patterns indicate absolute values up to 2 cm and 4 cm for L1 and L5, respectively. The impact of antenna corrections has been assessed in different multipath environments using a high-accuracy positioning algorithm employing an undifferenced observation model and applying ambiguity resolution. Successful ambiguity resolution is shown for a smartphone placed in a low multipath environment on the ground of a soccer field. For a rooftop open-sky test case with large multipath, ambiguity resolution was successful in 19 out of 35 data sets. Overall, the antenna calibration is demonstrated being an asset for smartphone-based positioning with ambiguity resolution, showing cm-level 2D root mean square error (RMSE).

The growing quality of smartphone-based Global Navigation Satellite Systems (GNSS) chipsets opens a new frontier for scientific research in positioning, navigation and timing ap- plications. The portability and affordability of these instruments could enhance the current GNSS receiver global network for atmospheric monitoring purposes. However, the quality of the measurements gathered from smartphones have not yet been fully assessed. In this paper, an analysis of the quality of smartphone-based Total Electron Content (TEC) mea- surements is performed. The primary focus of this work is to provide a general analysis on the potential of using smartphone observations for ionospheric sciences. Dual-frequency phase observations are used to measure the relative TEC. For this experiment, GPS L1/L5 and Galileo E1/E5a observations acquired with the Xiaomi Mi8 and Huawei Mate20 X smartphones were considered. Both devices are equipped with the Broadcom BCM47755 chipset, which enables GNSS dual-frequency measurements. More than 100 hours of phase observations at mid-latitude during a low solar activity period were gathered. Three differ- ent setup configurations were defined to assess the effects multipath or signal strength may have in the quality of the phase observations. In addition, to detect and discard unrealistic fluctuating phase observations, a quality-check was performed. In the results, good agree- ment between the slant TEC (sTEC) measurements from the smartphone and the sTEC obtained from a co-located geodetic receiver is presented. Furthermore, the amount and quality of observations discarded by the quality-check are reported, which emphasises the use of the signal strength to indicate the quality of phase observations. The results indicate that the C/N0 and multipath are important —when gathering the data from a geodetic antenna, around 80% of the collected data passed a quality threshold. However, collecting data with the addition of an attenuator, or directly from the smartphone antenna, reduced the valid data to below 50%. However, given the ease of use of a smartphone for data collection, even at 50% of data being usable, this shows potential as a useful course of TEC for ionospheric observations.

The main issue in the development of precise positioning is the way in which to send GNSS corrections. To handle this case, a terrestrial broadcast mechanism based on DAB+ (digital audio broadcasting) signals was chosen to overcome the scalability challenges, as it would allow a service provider to transfer assistance data based on a “one-to-many” scheme. DAB is easily widely deployed, with large coverage predictions carried using ATDI’s HTZ simulator. The DAB+ reception demonstrator uses SSRZ, a compressed and compact state space representation corrections format developed by Geo++. SSRZ corrections were generated using data from Teria’s CORS network and have been broadcasted over the air with DAB+ signals. To validate the SSRZ corrections, the “Record&Replay” technique was used. It consists of digitizing GNSS signals during a normal field test. Once data were collected and validated, replays were executed in the laboratory. Different scenarios were set up to validate the accuracy of the position with SSRZ corrections sent via DAB+ and the convergence to the corrected position after ambiguity loss. The results show that the accuracy was acceptable when the user remained close to the transmitting DAB+ antenna (<10 km). The lower performance might result from broadcast limitations in urban environments.