Environmental pollution from industrial factories via air deposition is an urgent problem worldwide. Phosphate fertilizers, derived from rock phosphate, are characterized by the presence of potentially toxic elements, such as Zn, Co, Pb, Ni, Cr, Mn, Fe, and Cu, which are dispersed in the form of solid dust-like materials from the pipes of the factory. This study aimed to investigate the effects of airborne industrial emissions on the chemical and biochemical compositions of cotton grown in the immediate vicinity of a fertilizer factory in Uzbekistan. The composition of airborne dust deposited on the plants, the chemical composition of the cotton leaves before and after washing, as well as that of above- and below-ground plant organs, and their protein contents were determined. The concentrations of macro- and microelements in the leaves and roots were determined using an atomic absorption spectrophotometer. The fluorine contents in the leaves and in the roots were determined using a fluorine-selective electrode. The radius of dispersion of industrial emissions in the air was best described by measuring the fluorine contents in washed and unwashed cotton leaves. The relationships among P, K, Mg, Ca, S, F, and Mn in plant roots and leaves as a function of distance from the pollutant source were analyzed. Based on the fluorine contents in washed and unwashed cotton leaves, the two following zones of technogenic pollution were distinguished: the zone < 5 km from the factory, with high technogenic pollution, and the zone > 5 km from the factory, with moderate technogenic pollution. It was found that the resistance of cotton to air pollution from industrial emissions is determined by the ability of cotton plants to neutralize toxic compounds by increasing the influx of alkaline earth metals into the affected tissues. This study showed the possibility of growing cotton at a distance of >5 km from the fertilizer factory. It is strongly recommended to analyze the chemical composition of plants located in a highly polluted zone only after the dust particles have been washed off of the plant’s surface. Despite the resilience of cotton to industrial pollution, the monitoring of areas identified as pollution zones is recommended.

The dissolution of Ca and Mg in soil and their translocation in plants from different families when using different doses of liming materials of industrial waste origin have not yet been sufficiently studied. In this study, the influence of increasing doses of ameliorants of carbonate (dolomite flour—DF) and silicate (blast furnace slag—BFS) natures on the change in acid–base properties of soddy-podzolic light loamy soil, yield, and chemical composition of plants of the families Gramíneae (spring wheat), Brassicáceae (spring rapeseed), and Leguminósae (vetch and beans) was studied in five-year pot experiments. In the five-year experiments, the ameliorant of a carbonate nature showed greater effect on soil acid–base properties than that of a silicate nature. A return to the initial state of soil pH was not established in any of the treatments. Both ameliorants showed similar effects on wheat straw biomass, but DF had a greater positive effect on wheat grain yield than BFS. Regardless of the dose of DF applied, the accumulation of Ca and Mg by the plants throughout the study period was higher than when BFS was applied. Among the studied plants, those of the family Brassicáceae were the most responsive to liming and, at the same time, showed high ecological adaptability. Differences in the effects of the two ameliorants on the soil chemical properties were more significant than differences in their effects on plant productivity.

The degradation of Calcisols in the arid regions of Central Asia constrains sustainable agricultural production because of low organic matter content, poor aggregate stability, nutrient limitations, and increasing climatic stress. This study evaluated a rhizosphere engineering approach based on the native plant growth-promoting bacterium Pseudomonas veronii Ps-S/Sh-1503/2022 for the rehabilitation of degraded Calcisols. Four-year field experiments (2022–2025) using Sorghum bicolor assessed plant growth, rhizosphere microbial indicators, physiological responses, pathogen suppression, crop productivity, and implementation feasibility through economic and environmental assessments. Inoculation with P. veronii increased root depth by 45%, improved aboveground biomass, increased the ratio of culturable bacteria to Fusarium spp. from 6.1 to 10.3, and reduced Fusarium abundance by 29.4%. Structural equation modeling suggested that trophic support (42.1%), aggregate stabilization (27.4%), biocontrol (23.3%), and defense-related responses (7.2%) were the principal pathways associated with soil rehabilitation. Economic assessment indicated that the combined inoculation and mineral fertilization treatment provided the highest profitability, while environmental assessment estimated potential reductions in mineral fertilizer use and greenhouse gas emissions. These findings suggest that rhizosphere engineering using a native P. veronii strain represents a promising, economically viable, and climate-smart approach for improving the biological functioning of degraded Calcisols and supporting sustainable agricultural production.