Adsorption processes, due to their technical simplicity and cost-effectiveness, have arisen as one of the most well-known, straightforward solutions to water pollution. In this context, polysaccharides, due to their abundance, biodegradability, and biocompatibility, are appealing raw materials for the design of adsorbents. Moreover, some of them, such as chitosan, can be obtained from organic waste products, and their use additionally contributes to solving another concerning problem: organic waste accumulation. Unfortunately, due to their low adsorption capacities and/or physicochemical properties, native polysaccharides are not suitable for this purpose. However, there are alternatives that can overcome these physical or chemical limitations, often taking advantage of the versatility of their polyhydroxylated structure. In this context, this review aims to present an overview of the advances from 2019 onwards in the design of new adsorbents for water treatment from cellulose, alginate, chitosan, and starch, addressing the two main strategies reported in the literature: the preparation of either polysaccharide-based composites or polysaccharide derivatives. It is important to point out that, herein, special emphasis is placed on the relationship between the chemical structure and the efficiency as adsorbents of the analyzed materials, in an attempt to contribute to the rational design of adsorbents obtained from polysaccharides.

Water quality is threatened by numerous pollutants, among which antibiotics are of great concern due to their widespread use and unaltered excretion, leading to water contamination and fostering antibiotic resistance. To comprehensively address sustainable water remediation, herein, the susceptibility to non-thermal plasma degradation of two veterinary antibiotics (Oxytetracycline (OTC) and Lincomycin (LNC)) are compared in an integral approach, including computational analyses, plasma irradiation assays, and a byproduct toxicity assessment. The computational assessment was performed by evaluating the ionization potential (IP) obtained from Density Functional Theory calculations and determining the antibiotics’ susceptible sites for radical attack. Plasma irradiation achieved nearly complete degradation (~100%) of both compounds with the initial concentration of 1 mg L⁻¹, while 60% degradation was observed when the starting concentration was 10 mg L⁻¹. The mineralization rates were 21% and 31% for OTC and LNC, respectively. The degradation profiles followed similar trends, as expected from their comparable IP values. After treatment, the solution exhibited lower biotoxicity compared to the original antibiotics. Therefore, this work represents a step forward in addressing one of the key environmental challenges of our time and encourages further extending the analysis towards the remediation of water polluted with many other organic compounds.

Chitosan was subjected to a crosslinking reaction with three polyhydroxylated diacids (glucaric (GlcA), mannaric (ManA), and mucic (MucA) acids) that only differ in the spatial orientation of their hydroxyl groups. This work aimed to obtain experimental evidence of the impact of the three-dimensional arrangement of the crosslinkers on the resulting properties of the products. In all the cases, the products were hydrogels, and their chemical structures were fully elucidated by FT-IR spectroscopy and conductometric titration. Thermogravimetric and morphological studies were also carried out. The specific surface area of all the products was similar and higher than that of native chitosan. Moreover, all hydrogels were characterized in terms of viscoelastic properties and long-term stability under external perturbation. Furthermore, their lead adsorption efficiency and swelling capacity were assessed. Despite the resemblant chemical structure in all the hydrogels, Ch/ManA exhibited the highest lead adsorption capacity, (Ch/ManA: 93.8 mg g⁻¹, Ch/GlcA: 82.9 mg g⁻¹, Ch/MucA: 79.2 mg g⁻¹), while Ch/GlcA exhibited a remarkably higher swelling capacity (i.e., ~30% more than Ch/MucA and ~40% more than Ch/ManA). The results obtained herein evidenced that the selection of the polyhydroxylated crosslinker with the appropriate three-dimensional structure could be crucial to finely adjust the final materials’ features.

Water pollution due to emerging organic pollutants, such as agrochemicals, has become a topic of growing interest worldwide. The increase of pollutants in aquatic systems stimulated the development of new strategies for water remediation. Plasma technology is an advanced oxidation process which has proved to be an efficient method for organic matter degradation. In this work, a novel design of a trielectrode plasma reactor based on a dielectric barrier discharge extended to a third electrode operated in ambient air is presented. The water to be treated flows through a gutter with low impedance and far from the electrodes connected to the voltage sources. The reactor operates in ambient air, and it does not rely on the use of expensive inert gases. The design of the reactor is easily scalable. The performance of the reactor, in terms of the removal efficiency and the energy yield, was tested in an aqueous solution of the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D), one of the most widely used around the world. The reactor presents a good efficiency in the removal of the herbicide 2,4-D and values of energy yield of about 240 mg/kW h.