Converting light energy to electrical energy in photovoltaic devices relies on the photogenerated electrons and holes separated by the built-in potential in semiconductors. Photo-excited electrons in metal electrodes are usually not considered in this process. Here, we report an enhanced photovoltaic effect in the ferroelectric lanthanum-modified lead zirconate titanate (PLZT) by using low work function metals as the electrodes. We believe that electrons in the metal with low work function could be photo-emitted into PLZT and form the dominant photocurrent in our devices. Under AM1.5 (100 mW/cm2) illumination, the short-circuit current and open-circuit voltage of Mg/PLZT/ITO are about 150 and 2 times of those of Pt/PLZT/ITO, respectively. The photovoltaic response of PLZT capacitor was expanded from ultraviolet to visible spectra, and it may have important impact on design and fabrication of high performance photovoltaic devices based on ferroelectric materials.
Crystalline silicon (c-Si) heterojunction (HJT) solar cells are one of the promising technologies for next-generation industrial high-efficiency silicon solar cells, and many efforts in transferring this technology to high-volume manufacturing in the photovoltaic (PV) industry are currently ongoing. Metallization is of vital importance to the PV performance and long-term reliability of HJT solar cells. In this review, we summarize the development status of metallization approaches for high-efficiency HJT solar cells. For conventional screen printing technology, to avoid the degradation of the passivation properties of the amorphous silicon layer, a low-temperature-cured (< 250 ℃) paste and process are needed. This process, in turn, leads to high line/contact resistances and high paste costs. To improve the conductivity of electrodes and reduce the metallization cost, multi-busbar, fine-line printing, and low-temperature-cured silver-coated copper pastes have been developed. In addition, several potential metallization technologies for HJT solar cells, such as the Smart Wire Contacting Technology, pattern transfer printing, inkjet/FlexTrailprinting, and copper electroplating, are discussed in detail. Based on the summary, the potential and challenges of these metallization technologies for HJT solar cells are analyzed.
1 November 2016 in ACS Applied Materials & Interfaces