The application spectrum of low cost material reinforced metal matrix composites is growing rapidly in various engineering fields. In this way, present study indicates the possibilities of reinforcing aluminium alloy (AlSi10Mg) with locally available inexpensive rice husk ash for developing a new material. A rice husk ash particle of 3, 6, 9 & 12% by weight were used to develop metal matrix composites using a liquid metallurgy route. The surface morphology was studied using scanning electron microscope for analyze the distribution of RHA particles. The mechanical properties such as tensile strength, compressive strength, hardness and percentage elongations are studied for reinforced RHA composites. The results reveal that the percentage reinforcement of RHA will increase ultimate tensile strength, compressive strength and harness of the composite
Rice husk ash of three different particle size ranges (50–75, 75–100 and 100–150 μm) a 3, 6, 9, and 12% by weight is reinforced with an aluminum alloy (AlSi10Mg) using the liquid metallurgy method. The dry sliding wear behavior of the composites in the cast conditions is examined using the pin-on-disc tribotesting machine for three different loads (20, 30, and 40 N) with three different sliding velocities (2, 3, and 4 m/s). The results reveal that the composite reinforced with the coarse rice husk ash particles exhibits superior wear resistance compared to the fine rice husk ash particles. The wear rate of the composite decreased with an increase in the weight percentage of rice husk ash particles for all size ranges. Finally, the wear mechanism was investigated with the worn surface using a scanning electron microscope.
Silicon nitride (Si3N4) is a widely used reinforcement material to improve the mechanical properties of the aluminium matrix composites. Aluminium alloy (AA 6063) matrix composite was produced with different wt. % of Si3N4 content through stir casting route. L27 orthogonal array was used to conduct the wear test in Pin-on-disc apparatus. The wear parameters were optimized by S/N ratio and ANOVA analysis. SEM images of the composites show the uniform distribution of Si3N4 particles in AA6063 matrix and its composition was confirmed by EDS analysis. As a result, the minimum wear rate was obtained for the composite contains 10 wt. % Si3N4, load of 29.43 N, sliding distance of 1500 m and the sliding velocity of 3 m/s. ANOVA result reveals that, the weight percentage of reinforcement has the higher percentage of contribution to influence the wear rate of the composite. The confirmation test was conducted and the results are well agreed with optimized parameters.