Cost and time for stamping die tryouts are significant within the car industry. A major contributing factor is that elastic deflections of stamping dies and presses are usually not considered during the virtual die design and forming simulation phase. Active surfaces of stamping dies are only cambered based on previous experiences of tool types and stamping presses. However, almost all stamping dies and presses are unique, and available experiences are not valid for new sheet materials. This leads to component deviations and often several loops of tool adjustments are needed. Previously partners within the SMART Advanced Manufacturing research project CAMBER have developed advanced deflection measuring devices to quantify the elastic deformations of stamping presses. Using these measurements, cambering methodologies can be utilized in sheet metal forming simulations. In this paper numerical substitutive stamping press models are described which are capable of compensating for measured stamping press dynamics. The result show that a numerical compensated tool can improve the contact by over 80% compared to the corresponding contact without compensation.
High-frequency shock-type vibrations (HFVs) from, e.g., impact wrenches with a frequency content mainly above 1250 Hz have long been suspected to cause a significant number of vibration injuries, HAVS. These vibrations are unregulated in the current standard for risk estimation, ISO 5349-1; thereby, the risk of injury is suspected to be underestimated. The objective of this study was to investigate the effects on finger tissue subjected to HFVs similar to those from impact wrenches by using a 2D finite element model of a fingertip. The model was validated through experiments. Using the input acceleration from the experiments, the model predicted high pressure variation and particular negative pressures at levels close to 0.1 MPa (1 Bar) or more, which are levels where cavitation in liquid can occur, with a detrimental effect on biological systems.