The present study examines the imprint of salt tectonics on carbonate depositional patterns of the Ionian zone platform edge to slope transition. The study area is part of an overturned rim syncline adjacent to a salt diapir. The Ionian zone is made up of three distinct stratigraphic sequences (pre-, syn- and post-rift sequences) represented by evaporites and shallow water carbonates at the base that pass gradually to a sequence consisting of pelagic limestones with shale intervals. In the study area, six cross sections were constructed, mainly covering the edge-to-slope overturned succession of Early Cretaceous to Eocene carbonates (post-rift stage) in the northern limb of the syncline. In the measured sections, abrupt changes in sediment texture resulted in the formation of distinct, thick-bedded carbonate layers, identified as packstones to grainstones–floatstones, with abundant fossil fragments, indicating deposition by debrites in a platform slope or slope-toe environment. Planar and ripple cross-lamination also suggest the involvement of turbidity currents in the depositional process. In the upper levels of the Lower Cretaceous carbonates, chert bodies with irregular shapes indicate soft sediment deformation due to instability of the slope triggered by salt intrusion. Internal unconformities identified in the field and in the available seismic data combined with the vertical to overturned dipping of the strata correspond to a basal megaflap configuration. Syn-sedimentary deformation resulted in the accumulation of debritic and turbiditic layers, while the compressional regime established in the area from the Late Cretaceous to Early Eocene enhanced the fracture porosity of carbonates, which could eventually affect the reservoir properties.

As industry moves from fossil fuels to green energy, substituting hydrocarbons with hydrogen as an energy carrier seems promising. Hydrogen can be stored in salt caverns, depleted hydrocarbon fields, and saline aquifers. Among other criteria, these storage solutions must ensure storage safety and prevent leakage. The ability of a caprock to prevent fluid from flowing out of the reservoir is, thus, of utmost importance. In this review, the main factors influencing fluid flow are examined. These are the wettability of the caprock formation, the interfacial tension (IFT) between the rock and the gas or liquid phases, and the ability of gases to diffuse through it. To achieve effective sealing, the caprock formation should possess low porosity, a disconnected or highly complicated pore system, low permeability, and remain strongly water-wet regardless of pressure and temperature conditions. In addition, it must exhibit low rock–liquid IFT, while presenting high rock–gas and liquid–gas IFT. Finally, the effective diffusion coefficient should be the lowest possible. Among all of the currently reviewed formations and minerals, the evaporites, low-organic-content shales, mudstones, muscovite, clays, and anhydrite have been identified as highly effective caprocks, offering excellent sealing capabilities and preventing hydrogen leakages.

This study is based on the detailed sedimentological analysis of eleven sections and one well through the late Eocene–Oligocene flysch formation of the Internal Ionian Zone (IIZ) in Western Greece. The sections are spread from the northern parts of Epirus to the north and Aitolokarnania to the south. Sedimentological data combined with biostratigraphic analyses resulted in a five-stage evolutionary model for the basin. Unit I corresponds to the lower part of the examined sections, indicating the onset of clastic sedimentation. Regarding depositional environments, it is regarded as a basin plain where lobe distal fringe accumulations occur. Unit II consists almost exclusively of heterolithic facies, marking the advance of a lobe complex system. Massive sandstone facies dominate unit III and can be considered a more proximal submarine fan system. Unit IV reflects a calm period of the basin, where mud-dominated heterolithics and hemipelagic mudstones were deposited. Hemipelagic mudstone facies with intervals of heterolithics, conglomerates, and deformed and massive sandstone facies characterize unit V. The architecture resembles a slope system incised by canyons and channels. The sand-rich intervals in Units III and V could act as the most favorable reservoir levels. In contrast, the sand-rich intervals in Unit II are considered less promising due to their higher heterogeneity.

The spatial distribution of sediments on the seafloor reflects the various dynamic processes involved in the marine realm. To analyze sediment transport patterns in the North Aegean Sea, 323 surficial samples were obtained and studied. The granulometry data revealed a diverse range of grain sizes of surficial sediments, ranging from purely sandy to clay. The predominant size classes were silt and muddy sand, followed by sandy silt and mud. However, there were very few samples that fell within the clay classes. The sorting coefficient ranged from 0.21 to 5.48, while skewness ranged from −1.09 to 1.29. The sediment transport patterns were analyzed based on the grain-size parameters (mean, sorting, and skewness). The results showed the variability of flow parameters involved in sediment distribution. River influx and longshore drift near the shoreline are the most significant factors affecting sediment transport. At the open sea, sediment distribution is mainly controlled by general water circulation patterns, especially by the outflow of low-salinity waters from the Black Sea through the Dardanelles and the Marmara Sea. The heterogeneity of sediment textural parameters across the study area suggests that seafloor sediments are further reworked in areas where water masses are highly energetic. It can be concluded that open sea water circulation controls sediment distribution patterns at the open shelf, while close to the coast, river discharge plays a key role.

The study area is part of the Pindos foreland (Underhill, 1985). Pindos foreland is a tertiary turbiditic foreland basin fill trending parallel to the external Hellenides and occupies Gavrovo and Ionian isopic zones (Aubouin, 1959). The age of Pindos foreland sediments is still a matter of discussion. B.P. (1971) proposed an early Miocene to middle Miocene age, explaining the presence of Oligocene fauna as a product of large scale erosion and reworking of older sediments during Miocene. IGSR&IFP(1966) suggested a late Eocene to early Miocene age for the basin fill while Fleury (1980), Leigh (1991), Wilpshaar (1995), Bellas (1997) assigned an Oligocene age. Avramidis et al (1999) proposes a middle Eocene to early Miocene age assessment, using nannofosil zones from three studied cross sections in the Klematia-Paramythia basin (middle Ionian zone). The determination of the sediment ages was based on the study of calcareous nannofossils, which came from almost 120 samples covering 11 geological cross sections. The nannofosil marker species that were found in the samples were classified using the biozones proposed by Martini in 1971. According to the age assessments arose from the studied samples, clastic sedimentation in the study area began in the Middle Eocene, with small differences among the basin. The end of clastic sedimentation seems to be at different times in different parts of the basin.