Polyurethane grouting material (polymer) has been widely used in rock mass fracture grouting. The previous test of polymer slurry grouting in planar fracture did not consider the influence of temperature; therefore, in this paper, a test of polymer slurry grouting in planar fracture was firstly conducted in order to explore the diffusion characteristics of polymer slurry. The results show that the preheating temperature of polymer slurry has a great influence on the diffusion of slurry in fractures, which should be considered in the research of polymer fracture grouting. In addition, the slurry temperature is related to the chemical reaction of the polymer itself. However, the existing polymer fracture grouting models ignore the influence of temperature and the chemical reaction of the polymer slurry itself, which lack the rationality to reveal the diffusion behavior of the polymer slurry in fracture. Therefore, in this paper, a chemical reaction-fluid dynamic (CF) model was established. In addition, the Particle Swarm Optimization (PSO) algorithm was used to obtain the chemical reaction kinetic parameters of the polymer slurry. Based on the CF model, the diffusion characteristics of the polymer slurry during the fracture diffusion process were calculated. The applicability of the CF model was verified by comparing the experimental data with the calculated results. Finally, the influence of polymer preheating temperature and ambient temperature on slurry fracture grouting behavior was explored by the CF model. The research in this article provides some theoretical reference for the design of grouting parameters in fracture grouting engineering.
31 August 2022 in Mathematical Problems in Engineering
Based on the inadequacy of groundwater pressure and other factors on interstitial pressure and slurry filling rate during synchronous grouting by groundwater action, a scaled-down simulation was carried out and the applicability of the simulation was verified by model tests based on the shield tunnel project of Metro Line 12 under Longzi Lake. The results show that during the synchronous grouting process, the pressure in the slurry filling area mainly depends on the grouting pressure, and the pressure in the gap increases with the increase of grouting pressure; the pressure distribution in the gap in the unfilled area is mainly controlled by the groundwater pressure, and the pressure in the gap is positively related to the groundwater pressure. After the slurry completely fills the gap, the overall pressure distribution in the shield tail gap is more uniform. The slurry filling rate decreases with increasing groundwater pressure and increases with increasing grouting pressure; the effects of changing slurry density and slurry viscosity on the pressure distribution in the interstitial space and the slurry filling rate in the shield tail are not significant. The degree of influence of each factor on the slurry filling rate was in the following order: grouting pressure > groundwater pressure > slurry density > slurry viscosity. The work carried out is a guide to the optimization of synchronous grouting process and parameter design in shield tunnels.