The objective of this study is to prepare CNT/AlSi10Mg composites using mechanical ball milling combined with SPS. The study investigates the influence of ball-milling time and CNT content on the mechanical and corrosion resistance of the composite. This is performed to address the challenge of CNTs dispersion and to understand how CNTs impact the mechanical and corrosion resistance of the composites. The morphology of the composites was characterized using scanning electron microscopy (SEM) transmission electron microscopy (TEM) and Raman spectroscopy, and the mechanics and corrosion resistance of the composite materials were tested. The results demonstrate that the uniform dispersion of CNTs can significantly enhance both the mechanical properties and corrosion resistance of the material. Specifically, when the ball-milling time was 8 h, CNTs were uniformly dispersed in the Al matrix. The CNT/AlSi10Mg composite shows the best interfacial bonding when the mass fraction of CNTs is 0.8 wt.%, with a tensile strength of −256 MPa. This is 69% higher than the original matrix material without the addition of CNTs. Moreover, the composite exhibited the best corrosion resistance.

In order to effectively solve the problem of strength and ductility mismatch of magnesium (Mg) matrix composites, carbon nanotubes (CNTs) are added as reinforcement. However, it is difficult to uniformly disperse CNTs in a metal matrix to form composites. In this paper, electrophoretic deposition (EPD) was used to obtain layered units, and then the CNTs/Mg layered units were sintered by spark plasma sintering to synthesize layered CNTs/Mg composites. The deposition morphology of the layered units obtained by EPD and the microstructure, damping properties, and mechanical properties of the composite material were analyzed. The results show that the strength and ductility of the composite sample sintered at 590 °C were improved compared with the layered pure Mg and the composite sample sintered at 600 °C. Compared with pure Mg, the composites rolled by 40% had a much higher strength but no significant decrease in ductility. The damping properties of the CNTs/Mg composites were tested. The damping–test-temperature curve (tanδ~T) rose gradually with increasing temperature in the range of room temperature to 350 °C, and two internal friction peaks appeared. The damping properties of the tested composites at room temperature decreased with increasing frequency. The layered structure of the CNTs/Mg had ultra-high strengthening efficiency and maintained its ductility. The layered units prepared by EPD can uniformly disperse the CNTs in the composites.