The conducting polymer poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) is a promising candidate for developing flexible electronics. The conductivity of this polymer can be increased via simple ultraviolet (UV) irradiation. This process can lead to enhanced performance and stability of organic photovoltaic (OPV) cells. We used micro-Raman spectroscopy, Kelvin probe force microscopy (KPFM), and quantum chemical calculations to map the energy band diagram and the electronic properties of PEDOT:PSS films irradiated with UV at various times. These procedures can explain how the observed changes in the macroscopic electronic properties of OPV cells arose from local changes in the carrier transport at the organic/organic and metal/organic interfaces. Micro-Raman spectroscopy indicates the effect of UV irradiation on PEDOT chains, which suggests a conformation change of PEDOT chains in the thin film. When UV irradiates the PEDOT:PSS film, the quinoid structure becomes the dominant conformation structure in the treated film. This change originates from the interaction between the dipole moment within the conjugate PEDOT chains and the electric field of the UV. Combining experimental results and theoretical calculations, we propose a gradient energy band for UV-treated PEDOT:PSS film that can reduce the barrier of the organic/organic heterojunction and can induce an interface dipole field at the organic/metal interface that simultaneously results in easy carrier extraction from PEDOT:PSS to metal and the enhancement of carrier transport from the active material to PEDOT:PSS.
25 October 2013 in Journal of Materials Chemistry C
Control of the operating voltage in organic thin-film transistor (OTFT) based photosensors is a very important issue, which can effectively enhance photosensitivity by reducing the contribution of the field-effect current to the output current under darkness. In this study, we show a highly sensitive flexible organic photosensor, which is made by the use of cross-linked poly(4-vinylphenol) as a polymer dielectric layer and N,N′-ditridecyl-3,4,9,10-perylenetetracarboxylic diimide (PTCDI-C13H27) as an n-type active layer on a transparent polyethersulfone (PES) substrate, by tuning both source–drain and source–gate voltages to around the threshold voltage (Vt = 3.0 V). Interestingly, a maximum photocurrent/dark current ratio was obtained when the operating voltage was reduced to around Vt. The time-response characteristics and sensitivity of the PTCDI-C13H27-based photosensor were investigated. Considerable interest has been focused on developing a flexible in-cell remote touch screen that should comprise photosensitive OTFTs and switch OTFTs simultaneously. In this work, both switch-OTFTs and photo-OTFTs can be formed on the flexible PES substrate by use of the same fabrication process. The electrical characteristics of switch-OTFTs under bending states are discussed in terms of photoluminescence and time-resolved photoluminescence measurements, as well as quantum theory calculations.
The built‐in electric field and surface Fermi level in the InAlAs surface‐intrinsic‐n+ structures were studied by room‐temperature photoreflectance. The samples were grown by molecular beam epitaxy with an undoped layer thickness of 1000 Å. The undoped layer was subsequently etched to 800, 600, 400, and 200 Å. Different chemical solutions were used in the etching process and the built‐in electric field is found independent of the etching process. While the surface Fermi level, in general, varies with the undoped layer thickness, there exists, for each Al concentration, a certain range of thicknesses within which the surface Fermi level is weakly pinned. From the dependence of electric field and surface Fermi level on the undoped layer thickness, we conclude that the surface states distribute over two separate regions within the energy band gap and the densities of surface states are as low as 1.02±0.05×1011 cm−2 for the distribution near the conduction band and 2.91±0.05×1011 cm−2 for the distribution near valence band.