The Chang 7 continental shale oil reservoir is tight. The recovery factor is extremely low, the remaining oil is very high, and injecting water to improve oil recovery effectiveness is too hard. Therefore, in this paper, physical simulation experiments of CO₂ huff-n-puff shale oil and NMR tests were conducted to study the cycle numbers and permeability on the recovery degree, as well as the characteristics of shale oil mobilization and the remaining oil micro distribution. The results showed that the cumulative oil recovery factors (ORFs) gradually increased in the natural logarithmic form, the single cycle ORFs decreased rapidly in exponential form with the huff-n-puff cycle number, and the biggest economic cycle numbers were between approximately 3 and 5. Furthermore, the higher the permeability, the higher the ORF, but the difference of ORF decreased between the two experimental samples with the cycles. In addition, the gap of production and recovery degree was large between the different scale pores, the ORF of macropores was 6–8 times that of micropores, and the final remaining oil was mainly distributed in the micropores, accounting for 82.29% of the total amount; meanwhile, the macropores comprised less than 0.5%. In the process of huff-n-puff, CO₂ flowed into macropores, mesopores, and smallpores under the pressure differential effect, but a small amount of CO₂ slowly diffused into micropores, resulting in the ORF of the former with more free oil being higher and the ORF of micropores with more adsorbed oil being lower. Therefore, promoting a better contact and reaction between CO₂ and shale oil of micropores is one of the key ways to effectively develop the Chang 7 continental shale oil and enhance oil recovery.

Spontaneous imbibition of water into tight oil reservoirs is considered an effective way to improve tight oil recovery. We have combined testing techniques such as nuclear magnetic resonance, mercury injection capillary pressure, and magnetic resonance imaging to reveal the distribution characteristics of oil and water during the spontaneous imbibition process of tight sandstone reservoir. The experimental results were used to describe the dynamic process of oil–water distribution at the microscopic scale. The water phase is absorbed into the core sample by micropores and mesopores under capillary forces that dry away the original oil phase into the hydraulically connected macropores. The oil phase entering the macropores will drive away the oil in place and expel the original oil from the macropores. The results of magnetic resonance imaging clearly show that the remaining oil accumulates in the central region of the core because a large amount of water is absorbed in the late stage of spontaneous imbibition, and the water in the pores gradually connects to form a “water shield” that blocks the flow of the oil phase. We propose the spontaneous imbibition pathway, which can effectively explain the internal mechanisms controlling the spontaneous imbibition rate. The surface of the core tends to form many spontaneous imbibition pathways, so the rate of spontaneous imbibition is fast. The deep core does not easily form many spontaneous imbibition pathways, so the rate of spontaneous imbibition is slow. This paper reveals the pore characteristics and distribution of oil and water during the spontaneous imbibition process, which is of significance for the efficient development of tight oil.

After multi-stage volume hydraulic fracturing in a shale oil reservoir, massive amounts of water can be imbibed into the matrix pores. One of the key imbibition characteristics of a shale reservoir is the imbibition water and its height distribution. Based on high pressure mercury injection (HPMI) experiments and nuclear magnetic resonance (NMR) analyses, this study quantitatively evaluated the pore-size distribution of Chang 7 continental shale oil reservoirs in Yanchang Formation, Ordos Basin. The pores could be divided into three types as micropores (≤0.1 μm), mesopores (0.1–1.0 μm), and macropores (>1.0 μm), while the volume of micropores and mesopores accounted for more than 90%. This demonstrated that there were strong heterogeneity and micro–nano characteristics. According to the spontaneous imbibition (SI) experiments, the cumulative proportion of imbibition water content was the largest in micropores, exceeding 43%, followed by mesopores around 30%, and that of macropores was the lowest, and basically less than 20%. The negative values of stage water content in the macropore or mesopore indicated that these pores became a water supply channel for other dominant imbibition pores. Additionally, combining the fractal theory with the NMR T₂ spectrum, the relative imbibition water and actual height were calculated in different pores, while the height distribution varied with cores and shale oil. The shorter the core, the higher was the relative height, while the radius of macropores filled with imbibition water was reduced. This indicates that the height distribution was affected by the pore structure, oil viscosity, and core length.