In the last few decades there has been a rapid increase in the number of piled foundations where the piles have been employed as settlement reducers; in some recent projects, the piles have been separated from the raft by a granular layer, which creates a more uniform pressure distribution on the raft bottom and reduces constraint reactions in the soil, foundation, and superstructure. A series of centrifuge model tests has been performed to investigate the load transfer mechanisms between a square rigid raft and a group of instrumented piles jacked in dry dense sand, in direct contact with the raft or separated from the raft by an interposed granular layer. The test results have shown that contact piles act as settlement reducers by diffusing the load applied to their heads to greater and deeper volumes of soil. The insertion of a deformable layer between a raft and pile heads does not ensure displacement compatibility, and the pressure diffused by the granular fill acts partly on the pile heads and partly produces shallow soil settlements, which mobilize negative skin friction on the upper part of the pile shaft. Noncontact piles act mainly as soil reinforcement.
This paper focuses on the properties of a crushable, uncemented, carbonate sand, retrieved from an artificial island to be used for petroleum production offshore of the United Arab Emirates. The sand was dredged from an offshore borrow area, placed hydraulically within engineered bunds to create the island and densified by vibroflotation. The results of a comprehensive laboratory testing programme are summarised in this paper, providing a set of mechanical properties for carbonate sand. The laboratory programme included static, cyclic and dynamic tests, the results of which are interpreted in a critical state soil mechanics framework, including stress dilatancy. The results of this testing programme contribute to on-going research on the behaviour of carbonate sands under static and cyclic loading conditions. The results are also compared with selected data for other carbonate and siliceous sands, and highlight the behaviour of crushable, carbonate sands used as hydraulic fills.
The paper presents the results of extensive centrifuge tests modeling rigid circular piled rafts laying on a bed of loose very fine silica sand. The tests were aimed at investigating the behavior of rafts on settlement reducing piles. The testing program included: an unpiled raft, rafts on 1, 3, 7 and 13 piles. In each test, some model piles were instrumented with load cells to determine the distribution of load along the shaft. Beneath the rafts, two types of model piles, close-ended and free headed were installed: quasi displacement (QD) and quasi-non displacement (QND) piles. The obtained results permitted figuring out the role of piles in terms of their effectiveness as settlement reducers and to quantify the load sharing mechanism between piles and the raft-soil contact. The tests were aimed at investigating the load transfer mechanisms adopted in the design approach, and in particular at validating a numerical code which can be used in engineering practice. The paper describes the details of experiments undertaken, the adopted procedures and some of the results; where not specified, all the experimental data given in this paper referred to model scale. The adopted numerical code is briefly described and its validation, via test results on quasi-non displacement piles, is also reported.
This paper describes a project-based cone penetration test (CPT) calibration on a carbonate sand fill that was hydraulically placed and subsequently densified by vibrocompaction. The project involved the development of an artificial island constructed offshore from the United Arab Emirates for oil and gas production. Carbonate sands have crushable grains and can be significantly more compressible than silica sands, so it was determined that the semi-empirical CPT-based correlations for silica sands were not applicable and a soil-specific calibration was needed for post-densification characterisation of density, shear strength and compressibility. The CPT calibration investigation was primarily undertaken in a centrifuge, and then checked with supplementary tests in a large calibration chamber. In this paper, analysis of the calibration data follows three different threads for comparison with more typical siliceous sands: (a) relationships between CPT tip resistance, void ratio and vertical effective stress; (b) a relationship between CPT tip resistance and state parameter; and (c) an approach based on cavity expansion theory, which provides predictive capability for the CPT once soil properties have been measured in the laboratory. The test results are compared with silica sands, in terms of void ratio or the state parameter ψ.