DC–DC converters are used in many power electronics applications, such as switching power supply design, photovoltaic, power management systems, and electric and hybrid vehicles. Traditionally, DC–DC converters are linearly modeled using a typical operating point for their control design. Some recent works use nonlinear models for DC–DC converters, due to the inherent nonlinearity of the switching process. In this sense, a standout modeling technique is the Takagi–Sugeno fuzzy exact method due to its ability to represent nonlinear systems over the entire operating range. It is more faithful to system behavior modeling, and allows a nonlinear closed-loop control design. The use of nonlinear models allows the testing of controllers obtained by linear methods to operate outside their linearization point, corroborating with robust controllers for specific applications. This work aims to perform the exact fuzzy Takagi–Sugeno modeling of a buck–boost converter with non-ideal components, and to design a discrete proportional–integral–derivative (PID) controller from the pole cancellation technique, obtained linearly, to test the controller at different operating points. The PID control ensured a satisfactory result compared with the stationary value of the different operating points, but it did not reach the desired transient response. Since the proposed model closely represents the operation of the buck–boost converter by considering the components’ non-idealities, other control techniques that consider the system’s nonlinearities can be applied and optimized later.
Renewable solar energy is an excellent alternative to conventional energy sources and, recently, it has shown remarkable growth on electrical power grid in various countries around the world. Maximum power point tracking (MPPT) has critical importance in solar energy generation since it increases the system's efficiency in many scenarios. Photovoltaic modules (PV) are influenced by environmental factors such as temperature and solar irradiation density, changing the amount of energy generated throughout the day. In order to extract the maximum available power from a PV, its necessary to use the MPPT technique, which considers the systems nonlinearities. Maximum power tracking (MPP) is done by tuning the duty cycle of the DC-DC converter, so that the PV's terminal voltage is modulated to match the environmental conditions. This tuning, generally, is dependent on sensor readings. Normally, only the modules voltage and current sensors are used, due to the low cost and ease of acquisition of these signals. However, intelligent techniques demand the usage of temperature and irradiation sensors, increasing the complexity of the systems implementation. The use of intelligent control techniques applied to the energy generation system has had a notable presence in recent publications. The high efficiency obtained from its application demonstrates that the use of intelligent systems in the decision-making process is a useful tool in obtaining maximum generation power. The objective of the present study is the development and simulation via MATLAB/SIMULINK of a battery charging system with solar energy, which consists of a PV, a Buck converter, a 12V battery, and the MPPT controller. The intelligent fuzzy logic MPPT technique (FLS) and the classical incremental conductance technique (INC) will be compared, both techniques using only voltage and current measurements.