Racking in asphalt pavements has always been the leading cause of pavement damage. This study aims at investigating the effects of mesostructure characteristics of asphalt mixture on the fracture behavior of semicircular bending (SCB) samples. To fulfill this objective, a two-dimensional (2D) finite-element model (FEM) of an asphalt mixture considering viscoelastic properties was established by using digital image processing (DIP) technology and a cohesive zone model (CZM). The FEM method was validated based on experimental results. On this basis, the whole process of crack initiation and propagation, the damage distribution of cohesive elements, and the effects of mesostructure characteristics (such as voids, interface strength between aggregate and asphalt mortar, and initial crack length) on damage and fracture behavior of SCB samples were analyzed. It was observed that with increasing porosity, the ultimate bearing capacity of the specimen decreased, and the cracks propagated towards the path with more air voids. The air voids far away from the crack propagation path had minimal effect on the ultimate bearing capacity of the specimen but could induce new damaged cohesive elements. With the decrease of the interface strength of aggregate-asphalt mortar, the maximum bearing capacity of the samples decreased, and the proportion of the cohesive elements with more significant damage at the interface increased accordingly. The resulting bearing capacity, fracture energy, and creep dissipation energy of the specimens reduced gradually with increasing initial crack length.
25 October 2021 in ACS Sustainable Chemistry & Engineering
Crystalline wax in asphalt binder greatly affects the low-temperature performance of the asphalt pavement, and the composition of the phase separation at the microscopic scale has not been completely determined. In this paper, it is demonstrated that of the different observing systems of a microscope, the reflected polarization system is the best method to observe the morphology of the crystalline wax clearly. The components of the phase separation (excluding asphaltene) is also validated. On this basis, base asphalts doped with pure wax and eight asphalts at three aging states were observed. The results showed that the shape of the pure wax changed first from round to polymorphic, and then to an aggregate with an increase in the carbon number of the pure waxes. In addition, aging increased the intermolecular force and solubility of the wax in the asphalt binder. Finally, low temperature reduced the solubility of the wax in the asphalt binder to form a crystalline wax, which can provide an explanation for the physical (thermoreversible) aging of the asphalt binder at low temperature.
Physical hardening (PH) is an important factor affecting the low-temperature performance of bitumen. At present, most PH characterizations are performed by the bending beam rheometer. To present an alternative method based on the Dynamic Shear Rheometer (DSR) equipment, this paper explores the possibilities of the 4 mm plate-plate test to investigate PH in bitumen. A variety of binders was selected, differing in their content of natural waxes, in crude origin, and production procedure. An aged sample was also included. The results show that a 20 min equilibrium period is sufficient to stabilize the sample temperature. To evaluate the PH, a time follow-up of 4 h was selected, as after 4 h the change in slope of complex modulus versus time drops below 1%. Further conclusions show that the physical hardening index (PHI) of bitumen is temperature- and frequency-dependent. This PHI is largest at 0 °C and increases when tested at lower frequencies. The non-waxy binder had almost no hardening, while the waxy binders showed evident hardening. Although the presence of wax is an important factor, the PHI of these binders is not directly related to the total wax content, which was determined by differential scanning calorimetry. In conclusion, the findings show that 4 mm DSR tests provide an effective approach to characterize PH of bitumen. Graphical abstract